RokStok

[realunlucky]

For those who think I’m off the lug with the recess.

What did it measure to?

Sent from my SM-S926U using Tapatalk

 

[PLhunter]

What did it measure to?

Sent from my SM-S926U using Tapatalk

It’s a small spot to get really flush with but with my dial calipers .093-.096 again hard to be totally certain on being perfectly level on the lug. But the play dough shows it’s compressing down to the top of the lug. The lug CANNOT be removed without damage. I’ve heated it gently. Tapped it to try and get some play and used vice grips. Never even budged a little. The factory one came right out with a decent tug.

 

[Runwilderness]

Got my red carpet call from UM today. Painless and very much appreciated.

I had made two changes to my order: one to 2 color cerakote last Spring and a last minute change to a trinity rail.

The cerakote change was correctly captured.

The trinity rail was not, however, when I had emailed to request the change I was told it was too late to formally change the order since the stock was in shipment but that they would add a note.

That note was missed/lost, but thanks to the call I was able to clarify the change, it was noted, and hopefully I’ll be looking it over in person in a couple of weeks.

 

[PLhunter]

Got my red carpet call from UM today. Painless and very much appreciated.

I had made two changes to my order: one to 2 color cerakote last Spring and a last minute change to a trinity rail.

The cerakote change was correctly captured.

The trinity rail was not, however, when I had emailed to request the change I was told it was too late to formally change the order since the stock was in shipment but that they would add a note.

That note was missed/lost, but thanks to the call I was able to clarify the change, it was noted, and hopefully I’ll be looking it over in person in a couple of weeks.

My notification it was shipped was when I requested the trinity rail as well, I didn’t get a ca but didn’t have any changes from original either.

 

[wapitibob]

It’s a small spot to get really flush with but with my dial calipers .093-.096 again hard to be totally certain on being perfectly level on the lug. But the play dough shows it’s compressing down to the top of the lug. The lug CANNOT be removed without damage. I’ve heated it gently. Tapped it to try and get some play and used vice grips. Never even budged a little. The factory one came right out with a decent tug.

I would take all of 5 minutes to modify and repost the inlet toolpath so there was a flat datum in front of the lug so the final qc could hit it with a go/no go gage and check the lug protrusion.

 

[PLhunter]

I would take all of 5 minutes to modify and repost the inlet toolpath so there was a flat datum in front of the lug so the final qc could hit it with a go/no go gage and check the lug protrusion.

I was told by UM today that those values were normal. The factory was .078. They said tikka’s dont sit dead like some upon working the action screws. I’ll shoot it again with lighter torque values. 45 inch lbs to start. See if that tightens things up as far as groups go. They also said the photos I sent look normal but that I might benefit from removing a bit from the shank area. The play dough photos didn’t look abnormal to them.

 

[WeiserBucks]

The one I just got has a MT lug and is .090" for whatever it's worth.