Dead Air Nomad Ti XC

[thinhorn_AK]

I held mine by hand and used my little impact driver with a big socket adapter to fit the hub adapter. Couple rattles from the impact and it spun off easily.

That worked so well, took like 2 seconds.

Thanks!!!

 

[HairyScandinavian]

That worked so well, took like 2 seconds.

Thanks!!!

Heck yeah, can't beat that impact rattle!

 

[khuber84]

Spanners will not damage the coatings, no.

 

[Matt5266]

I held mine by hand and used my little impact driver with a big socket adapter to fit the hub adapter. Couple rattles from the impact and it spun off easily.

This is what I've done as well. Worked when nothing else would

 

[Capt.Gene]

Edit 10/15/24
I have one here on a form 3 and will be testing it head to head against a scythe ti. Will also compare it to a DD Enticer Lti even though its not a direct comparison like the scythe.
If any of you have specific questions or testing you want to see, let me know.

View attachment 777636

I have that same model.

 

[JRS3]

You asking about the rear end cap or front? Rear cap, use the spanners that came with the
This is the ebrake wrench.
View attachment 914087

I’m trying to get the front cap off with this tool and it’s not budging so far. Any suggestions?

 

[JRS3]

Finally got it off but nowhere near as easy as the video.

 

[natedock1]

Scythe is a full inch shorter and 1.4 ounces lighter with a flat titanium front cap
We will see which one sounds better tomorrow
View attachment 777658View attachment 777659

I went through this thread and watched your videos and viewed your pictures as well as read your commentary. I wanted to thank you for the comprehensive information and easy to understand explanations for those of us like me new to exploring getting a suppressor. It helped me make up my mind and this was so much more enjoyable than reading a review by a professional writer on only 1 product rather than comparing two that he was most likely compensated for doing. So thanks again…awesome info and great job!