280 AI recoil w/o brake

TURNER208

FNG
Joined
Aug 8, 2017
Messages
75
Location
Idaho
Looking for some insight on how the recoil is in a 280 ai without a brake. I’ve been hunting with a 338 Win the last several years so wouldn’t say I’m overly recoil sensitive but know I could shoot better with a lesser recoiling rifle. I’d prefer to not use a brake as I’ve had a few bad experiences around them. This would be a rifle likely in the 8-8.25 overall weight. Let me know your thoughts
 

Slugz

WKR
Joined
Dec 31, 2020
Messages
652
I sent you a pm. Id say a little more than that but not much. I find it very close to a 30-06 load we make with 180gr bullets.
 
OP
T

TURNER208

FNG
Joined
Aug 8, 2017
Messages
75
Location
Idaho
Thanks @handwerk! Don’t know any buddies with one to shoot so I appreciate the insight. Looks like a sweet round and something different to try. Hear good things about them from everyone just never had the pleasure of shooting one
 

Mtndawger

FNG
Joined
Mar 11, 2021
Messages
65
I don’t use a brake on any of my rifles. My 280AI semi custom tikka scoped weighs in at 8lb 3oz. I can still reasonably spot my shots and shoot 20 rounds during a range session with no problems and I only weigh about 163lbs so not a big guy. One of the keys is I’m using an Alterra Arms carbon stock. It has a negative comb which helps in directing recoil back and not inducing muzzle rise. This also allows me to shoot with my head up instead of forward and glued to the stock. Stay away from traditional sporter stocks. The new Rokstok comes to mind and promises to be even better. Another thing is to have some mass in the barrel. Like a heavy sporter type barrel to balance the rifle, helping manage recoil that way too. I find this setup much easier and pleasant to shoot than my factory x bolt 308 win. As a point of comparison. 280 ai is a fantastic cartridge.
 

Bado20

FNG
Joined
Nov 12, 2021
Messages
56
Location
British Columbia
My primary rifle is an 8.25 lb scoped unbraked 280AI. Shooting 150's at 3010 fps feels pretty similar to a 30-06 with a 150gr bullet. No problems shooting it well positionally and off a bench. I definitely shoot it better than my 338 Win Mag.
 

Macintosh

WKR
Joined
Feb 17, 2018
Messages
2,717
Its made from a 30-06 case so holds about the same powder weight, shooting a 30-06-weight bullet, at +\- 3006 speeds—just very slightly more from the case shoulder. Therefore, until you start putting actual numbers to it, It’ll recoil very slightly more but pretty darn close to that 3006. Check out a recoil calculator and you can put an accurate number on it relative to what you are shooting.
 
Joined
Aug 18, 2024
Messages
1
I have a .280 AI Kimber Ascent, very light weight. I believe something like 4.75 lbs before scope. Have light Leupold 3.5-10X scope and rings. Have full power hand loads 140gr Nosler BT @3332 FT Per sec. Kicks like a mule. My software estimates it creates 3451 ft lbs of energy. Way more punishing than my .35 Whelen with full power hand loads, 180gr Barnes @ 3009 ft per second. Software says Whelen load creates 3618 ft lbs of energy, but heavier rifle. Kimber has a brake, Whelen is Magna Ported.
 

KHntr

Lil-Rokslider
Joined
Apr 24, 2014
Messages
165
Location
Northern British Columbia
I have a .280 AI Kimber Ascent, very light weight. I believe something like 4.75 lbs before scope. Have light Leupold 3.5-10X scope and rings. Have full power hand loads 140gr Nosler BT @3332 FT Per sec. Kicks like a mule. My software estimates it creates 3451 ft lbs of energy. Way more punishing than my .35 Whelen with full power hand loads, 180gr Barnes @ 3009 ft per second. Software says Whelen load creates 3618 ft lbs of energy, but heavier rifle. Kimber has a brake, Whelen is Magna Ported.
Pretty impressive to be leaning on a 280AI hard enough to hit 7 Ultra Mag velocities….

Especially from what must be a very short barrel, considering my 280AI Mountain Ascent was 5lbs 5oz out of the box.
 
Joined
Jun 15, 2016
Messages
2,826
I had a Forbes 280 AI and it kicked like a mule. Had it threaded so I could use a brake or can and it was much more tolerable. Sold it and wish I hadn’t.
 

bigunit

Lil-Rokslider
Joined
Dec 23, 2017
Messages
185
Location
Saskatchewan
My 280 is right at 8 lbs. 168 lrx at 2950 and the recoil is very manageable. The stockys vg2 stock helps a lot. I would say it's about the same felt recoil as my 7lb 308.
 

Vern400

WKR
Joined
Aug 22, 2021
Messages
495
I can't tell the difference between 280ai and 30-06 with a 150/165 grain. It's just a little more punchy than my 308. Barely noticeable but I run top end loads in the 308

I don't think I'd like a lighter rifle in those calibers.
I'm not steady enough to shoot a six and a half pound rifle well anyway.
 

6.5Express

Lil-Rokslider
Joined
Mar 31, 2013
Messages
214
Location
WY
My primary rifle is a Kimber subalpine 280 ackley. It is topped with a 3.5-10 NF SHV which brings it just over 7 lbs total hunting weight. Recoil is very manageable shooting a 145 Barnes lrx
 
Top