Tikka Barrel Removal and Install Tool Swap Thread

[Jaegerr]

Did you use a go gauge/no go gauge afterwards? I've experienced rifles which had a minimum chamber and then ammo that was on the maximum range which caused some brands or variations of ammunition to stick in the lands and pull the bullets. I would try another factory load or have an actual gunsmith take a look at it.

Jay

It’s my first tikka so I know the bolt slightly pulls forward when rotated but I could ever so slightly “feel” the go gauge but it chambered. I plan on letting a gunsmith look at it but I’m out of town for work most of the year so gotta attempt to find one in this area.

 

[pods8 (Rugged Stitching)]

I just ordered the SAC Tikka bushing set for my Bravo since all the other bushings in the kit suck for holding Tikka tapers.

Jay

It fits well

 

[Zackw]

I’d like to hop in line next for the tools, assuming they’re still in rotation.

 

[AkMtnRunner]

At least I know that I got the vice tightened down enough. In case anyone worries, this is mine.

 

[Nine Banger]

At least I know that I got the vice tightened down enough. In case anyone worries, this is mine.

Ouch.

I have that one but only use it for installs.

I use the Wheeler #1 flipped around backwards for removals.

 

[waspocrew]

At least I know that I got the vice tightened down enough. In case anyone worries, this is mine.

Yikes.

That’s why the external wrenches are recommended for barrel removal. The internal wrenches are designed to break before damaging your action.

 

[The Guide]

It is easy to remember...
OUTSIDE (wrench) = OFF
INSIDE = INSTALL

Do it any other way and you risk damage.

Jay

 

[mtnbound]

At least I know that I got the vice tightened down enough. In case anyone worries, this is mine.

Ohh, it’s definitely yours now.

 

[Nine Banger]

The side with TIKKA on it would make a fine key chain.

 

[uglymud]

I've only pulled one so far, using the PMA vise not the viper, but they're fairly similar. I used a piece of toilet paper tube and hit it with the impact to tighten. Hit it a second time when it slipped just a bit but after that it popped off fairly easy.

Sent from my SM-S908U using Tapatalk