The Rokslide 95 (Ruger American 😁)

[M4Madness]

How's the stock?

Seems to be well made. It's supposedly lighter than the original Magpul Hunter, but I don't have one to compare it to. It's definitely heavier than the factory Tupperware (which I actually thought was an okay stock). The whole set-up is a tank with the thermal optic, stainless steel suppressor, and the new Magpul stock. I haven't had a chance to shoot it in the new configuration.

 

[Undrgrndprdcts]

Seems to be well made. It's supposedly lighter than the original Magpul Hunter, but I don't have one to compare it to. It's definitely heavier than the factory Tupperware (which I actually thought was an okay stock). The whole set-up is a tank with the thermal optic, stainless steel suppressor, and the new Magpul stock. I haven't had a chance to shoot it in the new configuration.

Keep us updated on the ergonomics and how it shoots.

 

[M4Madness]

Keep us updated on the ergonomics and how it shoots.

Will do. For the $150 I gave for the stock, I'd venture to guess that it's well worth that, if only to gain an AICS magazine over the factory rotary one.

 

[BLJ]

Pulled the scope off of this one just to put it back on
Wanted to check zero.
I was initially low and right after putting the scope back on.
Adjusted and shot 10, then 20.

Moved it back right one click.

Should be okay.

 

[MT_Wyatt]

Has anyone had any issue with weak ejection? My Gen 1 7.62 is getting bad again about dribbling them out after firing like an old man standing at a urinal!

I previously stripped the bolt, cleaned, and reassembled with only a small amount of white lithium grease on firing pin spring. It was better but still not as good as other Americans I’ve shot. Any tips or suggestions?

I got a gen 2 5.56 that literally just won’t eject 4 out of 5 times now.

 

[Deere_Man]

I got a gen 2 5.56 that literally just won’t eject 4 out of 5 times now.

Do you have an extractor issue or is the chamber in need of polishing?

 

[MT_Wyatt]

Do you have an extractor issue or is the chamber in need of polishing?

Not 100% sure - I think it’s extraction.