RokStok

[Sadler]

So, I had to shim the action bolt holes because the action was sitting too low in the stock. The magazine latch wouldn't function and the bolt was extremely stiff. Putting a shim in cleared up both of those issues. My question is, are the shims fine long term or should I figure something else out?

Sent from my SM-S901U using Tapatalk

I’ve had to do that for both of my tikka actions with factory bottom metal.

 

[deerhunter628]

I had to shim my Christinsen Arms LA in both of my LA Rokstoks. No long term reports yet, but i could not cycle the bolt without the shim washers.

 

[Grundy53]

What action and what bottom metal?

Remington 700 UM M5

Sent from my SM-S901U using Tapatalk

 

[Grundy53]

Did you just use the appropriate size washers for shims under the bottom metal?

I don't know the appropriate size. So probably not. Lol

Sent from my SM-S901U using Tapatalk

 

[Formidilosus]

Remington 700 UM M5

Sent from my SM-S901U using Tapatalk

If you used washers, it should be fine, but personally I would bed it after the season.


For others- the R700 pattern actions are not all exactly the same. That’s why chassis can be very loose fits depending on whose action is put in. I’ve got three different R700 pattern custom actions, and they are not interchangeable in stocks when bedded, or when the inlet is tight. They are close generally, but tweaking the inlet is a thing with them.

 

[deerhunter628]

If you used washers, it should be fine, but personally I would bed it after the season.


For others- the R700 pattern actions are not all exactly the same. That’s why chassis can be very loose fits depending on whose action is put in. I’ve got three different R700 pattern custom actions, and they are not interchangeable in stocks when bedded, or when the inlet is tight. They are close generally, but tweaking the inlet is a thing with them.

Are you saying that bedding the action should eliminate the need for shims in the Rem 700?

 

[Grundy53]

If you used washers, it should be fine, but personally I would bed it after the season.


For others- the R700 pattern actions are not all exactly the same. That’s why chassis can be very loose fits depending on whose action is put in. I’ve got three different R700 pattern custom actions, and they are not interchangeable in stocks when bedded, or when the inlet is tight. They are close generally, but tweaking the inlet is a thing with them.

Thank you

Sent from my SM-S901U using Tapatalk

 

[Formidilosus]

Are you saying that bedding the action should eliminate the need for shims in the Rem 700?

I was saying that I would bed the action and bottom metal.

 

[deerhunter628]

I was saying that I would bed the action and bottom metal.

Ok. Thanks. I have bed actions but i have never bed bottom metal. I will need to study up on youtube