RIP XV experience? (Other light gpi suggestions)

[Prestjd]

Which neck collars are you looking at using Christopher.Reed?

 

[Christopher.Reed]

Which neck collars are you looking at using Christopher.Reed?

Frankly, I haven’t decided yet as I’ve never used them and haven’t seen a ton of options available.

My original thoughts was to use a 10g titanium IW collar on both ends of the arrow as that nock/collar combinations weight would match my lighted nock but, that would be a pretty expensive solution with almost $12 of titanium per arrow.

Do you use them? If so, what’s your recommendation?


Sent from my iPhone using Tapatalk

 

[Bump79]

There's quite a few options out there. Gold Tip sells them and so does Carbon Express. Over a nock collar - I'd go with a insert that takes the .204 down to a .166 nock.

Ethics and Gold Tip sells them, maybe Easton. You could do pin nock as well.

 

[HNTR918]

I'm looking at the RIP XV for my next build as well, and I will probably use Iron Will front components again.

 

[Bump79]

I'm looking at the RIP XV for my next build as well, and I will probably use Iron Will front components again.

AeroInsert-H for 0.202" - 0.207" ID Arrows [Light] (12)

The AIH2L* is an AeroInsert designed for archers who want to equip their 0.202" - 0.204" ID arrows with the AeroConcept System for self-concentricity, reliability, and harmonic dampening.

firenock.com

CTI20 AeroConcept Carbon Inner Tube (12)

Carbon Inner Tubes pair with AeroInsert-H to form the AeroConcept System to harmonically dampen your arrow for more consistent and flatter flight.

firenock.com

You should try this system out in Steel or Ti.

 

[Arrow4Christ]

I’m a big fan of the RIP XV. I’m shooting them with the Ethics HIT insert and end cap, which I feel is one of the best ways to reinforce the end of the arrow since the insert goes so deep into the shaft. They’re not totally bomb proof, but they are plenty durable for me and give me the weight and FOC I’m looking for in the 250 spine.

 

[sndmn11]

I’m a big fan of the RIP XV. I’m shooting them with the Ethics HIT insert and end cap, which I feel is one of the best ways to reinforce the end of the arrow since the insert goes so deep into the shaft. They’re not totally bomb proof, but they are plenty durable for me and give me the weight and FOC I’m looking for in the 250 spine.

Steel or aluminum Ethics?

 

[Arrow4Christ]

Steel or aluminum Ethics?

Aluminum for me. Has been plenty durable and gets me to the exact final weight I want with 125 grain broadheads.