Cutting Edge 132 gr maximus for 7 Rem Mag

[Timber_Cruiser]

Hey there folks,

Long time lurker, first time poster.

I just ordered some 132 gr cutting edge Maximus FCG for my 7mm rem mag, can't beat that black Friday deal, 20% off and free shipping.

I have been handloading 160 gr Federal fusions over H1000, accuracy is just under MOA and thats plenty for me.

I have been wanting to try out some other bullets for some time. With the introduction of the new tipped fusion line, I can't find the 160 gr "OG" fusions. Couple that with the above mentioned black Friday deal and here I am.

Long story short is, I can't find any sort of load data for using H1000 and a lighter bullet. I have never loaded mono metals. Powder of any kind is hard to find locally here. I also haven't seen anyone posting about the 132 gr maximus for 7 rem mag either. Does anyone have first hand experience loading these and have any recommendations?

I am thinking of H4350 which might me locally available or ramshot hunter or magnum bought online.

Rifle is a stock Rem 700 stainless sps, 1:9.25" twist in a 26" barrel. Based on everything I have seen the 132 should stabilize (min required is 1:10") but the 152's would not (min required is 1:9").

Apologies if this has been covered already and I was unable to find it. If it has been covered, I would appreciate if you could point me to it.

 

[jerm8352]

Contact Cutting Edge. They will give you load data.


https://cuttingedgebullets.com/pages/load-data

 

[Timber_Cruiser]

I did, they sent me the quick load output for it. Just scored some ramshot magnum for $30/# on midway. I'm going to give that a shot. Gonna back off 5% of the quick load max recipe.

I would appreciate any input or reviews of the 7mm 132 gr maximus rounds, I haven't found much for the 132's.

 

[pods8 (Rugged Stitching)]

I have been handloading 160 gr Federal fusions over H1000, accuracy is just under MOA and thats plenty for me.

I have been wanting to try out some other bullets for some time. With the introduction of the new tipped fusion line, I can't find the 160 gr "OG" fusions.

Are these the ones you’re talking about? I got a bunch if so.

 

[Timber_Cruiser]

Are these the ones you’re talking about? I got a bunch if so.

View attachment 800856

Those are the ones, I have a box and some left. I like them but I've also been thinking of going monolithic. I sent federal an email to see if they were going to offer the tipped fusions as a component and they never responded. How much do you have and how much you asking for them?

 

[pods8 (Rugged Stitching)]

Those are the ones, I have a box and some left. I like them but I've also been thinking of going monolithic. I sent federal an email to see if they were going to offer the tipped fusions as a component and they never responded. How much do you have and how much you asking for them?

Not holding ya back from monos, just noted you said you couldn’t find them.

I have over a thousand bulk packed I believe. Dunno the going rate, $.30ea + shipping?