Timber_Cruiser
FNG
- Joined
- Sep 2, 2022
- Messages
- 1
Hey there folks,
Long time lurker, first time poster.
I just ordered some 132 gr cutting edge Maximus FCG for my 7mm rem mag, can't beat that black Friday deal, 20% off and free shipping.
I have been handloading 160 gr Federal fusions over H1000, accuracy is just under MOA and thats plenty for me.
I have been wanting to try out some other bullets for some time. With the introduction of the new tipped fusion line, I can't find the 160 gr "OG" fusions. Couple that with the above mentioned black Friday deal and here I am.
Long story short is, I can't find any sort of load data for using H1000 and a lighter bullet. I have never loaded mono metals. Powder of any kind is hard to find locally here. I also haven't seen anyone posting about the 132 gr maximus for 7 rem mag either. Does anyone have first hand experience loading these and have any recommendations?
I am thinking of H4350 which might me locally available or ramshot hunter or magnum bought online.
Rifle is a stock Rem 700 stainless sps, 1:9.25" twist in a 26" barrel. Based on everything I have seen the 132 should stabilize (min required is 1:10") but the 152's would not (min required is 1:9").
Apologies if this has been covered already and I was unable to find it. If it has been covered, I would appreciate if you could point me to it.
Long time lurker, first time poster.
I just ordered some 132 gr cutting edge Maximus FCG for my 7mm rem mag, can't beat that black Friday deal, 20% off and free shipping.
I have been handloading 160 gr Federal fusions over H1000, accuracy is just under MOA and thats plenty for me.
I have been wanting to try out some other bullets for some time. With the introduction of the new tipped fusion line, I can't find the 160 gr "OG" fusions. Couple that with the above mentioned black Friday deal and here I am.
Long story short is, I can't find any sort of load data for using H1000 and a lighter bullet. I have never loaded mono metals. Powder of any kind is hard to find locally here. I also haven't seen anyone posting about the 132 gr maximus for 7 rem mag either. Does anyone have first hand experience loading these and have any recommendations?
I am thinking of H4350 which might me locally available or ramshot hunter or magnum bought online.
Rifle is a stock Rem 700 stainless sps, 1:9.25" twist in a 26" barrel. Based on everything I have seen the 132 should stabilize (min required is 1:10") but the 152's would not (min required is 1:9").
Apologies if this has been covered already and I was unable to find it. If it has been covered, I would appreciate if you could point me to it.
