Cutting Edge 132 gr maximus for 7 Rem Mag

[Timber_Cruiser]

Hey there folks,

Long time lurker, first time poster.

I just ordered some 132 gr cutting edge Maximus FCG for my 7mm rem mag, can't beat that black Friday deal, 20% off and free shipping.

I have been handloading 160 gr Federal fusions over H1000, accuracy is just under MOA and thats plenty for me.

I have been wanting to try out some other bullets for some time. With the introduction of the new tipped fusion line, I can't find the 160 gr "OG" fusions. Couple that with the above mentioned black Friday deal and here I am.

Long story short is, I can't find any sort of load data for using H1000 and a lighter bullet. I have never loaded mono metals. Powder of any kind is hard to find locally here. I also haven't seen anyone posting about the 132 gr maximus for 7 rem mag either. Does anyone have first hand experience loading these and have any recommendations?

I am thinking of H4350 which might me locally available or ramshot hunter or magnum bought online.

Rifle is a stock Rem 700 stainless sps, 1:9.25" twist in a 26" barrel. Based on everything I have seen the 132 should stabilize (min required is 1:10") but the 152's would not (min required is 1:9").

Apologies if this has been covered already and I was unable to find it. If it has been covered, I would appreciate if you could point me to it.

 

[jerm8352]

Contact Cutting Edge. They will give you load data.


https://cuttingedgebullets.com/pages/load-data

 

[Timber_Cruiser]

I did, they sent me the quick load output for it. Just scored some ramshot magnum for $30/# on midway. I'm going to give that a shot. Gonna back off 5% of the quick load max recipe.

I would appreciate any input or reviews of the 7mm 132 gr maximus rounds, I haven't found much for the 132's.

 

[pods8 (Rugged Stitching)]

I have been handloading 160 gr Federal fusions over H1000, accuracy is just under MOA and thats plenty for me.

I have been wanting to try out some other bullets for some time. With the introduction of the new tipped fusion line, I can't find the 160 gr "OG" fusions.

Are these the ones you’re talking about? I got a bunch if so.

 

[Timber_Cruiser]

Are these the ones you’re talking about? I got a bunch if so.

View attachment 800856

Those are the ones, I have a box and some left. I like them but I've also been thinking of going monolithic. I sent federal an email to see if they were going to offer the tipped fusions as a component and they never responded. How much do you have and how much you asking for them?