ChadS
Lil-Rokslider
No I had plans to make them until I I realized that I would be under spined with a 330 and that much weight up front out of an 80lb bowYou found a 50 gr insert for the Injexions?
No I had plans to make them until I I realized that I would be under spined with a 330 and that much weight up front out of an 80lb bowYou found a 50 gr insert for the Injexions?
No I had plans to make them until I I realized that I would be under spined with a 330 and that much weight up front out of an 80lb bow
What did you end up going with?Last year I was shooting with three other guys at Easton that were testing the FMJ injection while I was shooting the FMJ 340. I was pulling the same if not a bit more lbs and every time they were all getting farther penetration (about 3"-6" more) on the 3D targets than I was. Never has the standard FMJ looked so FAT as it did that day!
I just got the Injection FMJ 330's and am trying to figure out if I should do a 3x or 4x vane setup. Also debating on a 125 grain broadhead (Slick Trick or Solid fixed blades for Idaho Elk, 125 grain Ulmer Edge for Utah) over the standard 100 grain. Will have to figure out FOC of each setup.
My current setup which I'll use on my Hoyt Alpha Max 35 is the FMJ 340, Nitro 2" Vanes, 4" wrap, standard 20 grain insert and 100 grain Grim Reaper Razor Tip.
Will also be testing the Easton da'Torch with a 75 or 50 grain brass insert, 2" Blazers, 4" wrap, 100 grain Ulmer Edge and Nockturnal Lighted Nock.
Yea, I'm very undecided as of yet. Any feedback on any of these setups is appreciated.