What did you do in the reloading room today?

[49ereric]

Yesterday I sized, primed & flared 100 357 mag Norma brass and finished them today with 300MP & Northeast reloading’s 158 gr JSP & Lee factory crimp die.
Stopping the 357 loading until I get a lever rifle and see how they run.

 

[Castle Rock]

I tiled a bathroom
Shitty job but I prefer it to reloading

 

[JF_Idaho]

Got my new autotrickler v4 setup. Loaded 80 rounds of 6.5cm with h4350 and prepped another 100 pieces of brass that are now ready to load.

Impressed with the v4. I would say it probably runs 3 to 4 times faster than the chargemaster.

 

[Austin Kaufman]

Loaded a few hundred more rounds for PRS, NRL, and some 223s for my trainer. Shot up 400 rounds of 68 grain BTHP hornady bullets last week that I loaded and going back to 73 ELDMs for practice. Not pleased with the 68s over the few loads I tried and at distance the 73s seem better to me.


Sent from my iPhone using Tapatalk

 

[Gbrecka]

50 rounds of 223 with TMKs and 8208

 

[Luked]

Got everything now to start loading for my new to me 6.5 PRC other than Brass.
Haven't decided on what I want to do there.
Will probably start with the old cheap Hornaday for a while.
but thought of buying some ADG or Something higher end as this will probably be my main rifle for some time.
At least till the 6 Creed in Tikkas are readily avalible.

 

[ResearchinStuff]

Got everything now to start loading for my new to me 6.5 PRC other than Brass.
Haven't decided on what I want to do there.
Will probably start with the old cheap Hornaday for a while.
but thought of buying some ADG or Something higher end as this will probably be my main rifle for some time.
At least till the 6 Creed in Tikkas are readily avalible.

Don't pick adg. Only bad brass I've ever tried.

 

[Luked]

Don't pick adg. Only bad brass I've ever tried.

Interesting.

 

[Harvey_NW]

Don't pick adg. Only bad brass I've ever tried.

ADG has been great in my 6.5 PRC and was fine out of the box, not sure if something happened in production or QC process but my new 7 PRC brass necks looked atrocious.

 

[mills0713]

50 rounds of 223 with TMKs and 8208

How much 8208?

 

[Gbrecka]

How much 8208?

22.5 -23 shoots well for me

 

[JF_Idaho]

ADG has been great in my 6.5 PRC and was fine out of the box, not sure if something happened in production or QC process but my new 7 PRC brass necks looked atrocious.

That sucks. Did you end up contacting them?

I bought 2 50 count 6.5prc probably about 4-6 months apart. Both were immaculate out of the box.

 

[Harvey_NW]

That sucks. Did you end up contacting them?

I bought 2 50 count 6.5prc probably about 4-6 months apart. Both were immaculate out of the box.

No, I just ran them over an expander and prepped them like I used to with cheap bagged brass. Probably not worth my time to banter with them about it, but I'll probably keep an eye out for Lapua in the future.

 

[Reece123]

Trimming 400 pieces of 6.5 creed brass.