What did you do in the reloading room today?

[TSnave]

Cleaned and organized. It was a freakin' disaster in there. Hung the wall tapestry that my Marine FIL gave me...

 

[mthunter1989]

Over the past few sessions I've done mostly 22 ARC stuff. Actually sorted a box of 75gr ELD-Ms since loading them to mag length resulted in approximately half of the 10 being over 2.260". That was before measuring to the lands, just trying to set them at mag length. After measuring, and then figuring out how far to set back the longest bullets to Hornady's length of 2.250", I figured out that I'm jumping about .065" to the lands.

Today loaded up 10 of the ELD-Ms half a grain under max of Accurate 2520 to test. Also loaded 5 each of 75gr BTHP match bullets, at two different charges of IMR 8208XBR to test. I've only got a pound of that, should have bought more when it was in stock. But still want to try it out and see.

I've also really been contemplating picking up a MEC Jr kit and dive into reloading for shotguns....

 

[WestTN2288]

Over the past few sessions I've done mostly 22 ARC stuff. Actually sorted a box of 75gr ELD-Ms since loading them to mag length resulted in approximately half of the 10 being over 2.260". That was before measuring to the lands, just trying to set them at mag length. After measuring, and then figuring out how far to set back the longest bullets to Hornady's length of 2.250", I figured out that I'm jumping about .065" to the lands.

Today loaded up 10 of the ELD-Ms half a grain under max of Accurate 2520 to test. Also loaded 5 each of 75gr BTHP match bullets, at two different charges of IMR 8208XBR to test. I've only got a pound of that, should have bought more when it was in stock. But still want to try it out and see.

I've also really been contemplating picking up a MEC Jr kit and dive into reloading for shotguns....

Would like to hear how those 75 bthps do….

And what COL did you land on with those?

 

[Luked]

Loaded up some 300Blk for my daughters rifle to get ready for the Youth deer season coming up.

 

[Backcast88]

Did some 30-06 work.
- Resized a mixed lot of 25 pcs of brass for fouler/sighter rounds.
- Loaded said mixed brass with 57g H4350 and 165 BTSP.
- Loaded 12 trial rounds of n555 and 165 GS.

Fine tuned some 6.5PRC ammo.
- Loaded a few .005 closer the lands.
- Loaded a few .5g more powder.

Dispensed some BH209 for muzzlelaoder season that's right around the corner.

 

[SloppyJ]

Finally had a chance to test some loads today. I think I'm set for 6 creed and 300prc.

I had the weirdest thing happen. Previously I had really good results with N570 in my 300prc. So good I loaded 50 of them. Today I verified them, they grouped pretty damn well but half of them would shoot right at 2800fps and the other half were 2840. The odd thing is the variation was only 1 or 2 fps off of either velocity extreme. Same powder, primers, brass, and bullets. I think I'm going to stick with H1000. I have a feeling it's primer related because my H1000 loads with the same WLRM primers are all over the place with ES/SD.

The Tikka was spraying the 77tmks but I have a load that's good enough. I've been spoiled with my NX8s so shooting the 3x9 trijicon on my son's rifle for groups is a little more challenging.

 

[mthunter1989]

Would like to hear how those 75 bthps do….

And what COL did you land on with those?

Really didn't shoot that good for me. 2"+ on the two five shot groups I shot, while the 75gr ELD-Ms went under an inch for 10 shots. Overall length on them was 2.150" plus or minus like six thou on each side of that, and that was jumping about .030" to the lands.

 

[SloppyJ]

Would like to hear how those 75 bthps do….

And what COL did you land on with those?

75 BTHPs run great for me at 20 off in a Tikka. I was worried because I stocked up on 2k of them for cheap but they're great so far. Honestly they shoot a bit better than 77tmks for me in my son's tikka.

 

[WestTN2288]

Really didn't shoot that good for me. 2"+ on the two five shot groups I shot, while the 75gr ELD-Ms went under an inch for 10 shots. Overall length on them was 2.150" plus or minus like six thou on each side of that, and that was jumping about .030" to the lands.

Since I asked, I loaded some up myself. Got good velocity and kinda meh accuracy. I just set them to 2.12 and gave it a shot. May try walking them out a little longer. Same experience with the 75eld-m in my arc also though, they shoot significantly better as it stands now.

Having a load for the bthps is tempting to figure out when you factor in the price difference