Tikka and Sportsmatch Rings. Am I looking at this right?

[Bcleck90]

I’m setting up a Tikka .223 for my girlfriend using Sports Match TO84 rings. First time using these so want to make sure I’m looking at this right.

What hole in the receiver are you guys using for the ring with the pin in the bottom?

Has anyone had any issue with the pin not fitting in the two smaller holes?

 

[Haggin]

Just went through this. I used the larger one and pushed the pin as far forward as possible and with some force. It’s a roll pin but I don’t think it was going into those smaller holes.

this video helped. It’s for the sako rings but you get the idea.

 

[PNWGATOR]

Largest hole in the front part of the receiver.

If the pin is too long, tap it into the ring base a bit further.

Apply forward pressure to the ring with the pin when tightening.

Follow this process:

Scope mounting to maintain zero

After multiple requests for an explanation of how to mount a scope in order to have the lowest possibility of loss of zero, a discussion of a scope mounting video, and the latest thread about scope bases and action screw coming loose, I took some pics of what I do with a rifle when I get it and...

www.rokslide.com

 

[fightthenoise]

Just went through this. I used the larger one and pushed the pin as far forward as possible and with some force. It’s a roll pin but I don’t think it was going into those smaller holes.

I did the same thing.


Sent from my iPhone using Tapatalk

 

[Bcleck90]

Thanks guys. I just assumed that it was going to fit one of the smaller holes but I don’t think there’s anyway that’s going to happen.

 

[carsonkeys]

Tagging in so I can find and follow this weekend. Thanks for the info!

 

[Castle Rock]

Plenty of options for positioning the rings, I don’t use the pin provided because I like the front ring further forward
I put a pin at the back

 

[Reddish]

Plenty of options for positioning the rings, I don’t use the pin provided because I like the front ring further forward
I put a pin at the back View attachment 309518View attachment 309519View attachment 309520View attachment 309521

is taht the factory pin in the top pic? Did you just tap it in? I need the pin in the rear hole for the opposite reason...I need the front ring farther back.

 

[Castle Rock]

It is a pin cut from a 3 mm drill, used grease in the hole so it will come out if needed, it was a real snug fit