Suppressed tikka t3x 223 barrel length ?

[Joshuajosh]

Curious what barrel length I should go with when cutting my tikka 223 barrel, I don’t know what suppressor to go with either or thread pitch, I’d love to have something I could use for my 300wsm as well but I know that’s a jump and that barrel is 5/8-24

 

[pods8 (Rugged Stitching)]

You can get it threaded with a shoulder added to it can be 5/8-24 but for a 223 I wouldn't since most 223 cans are 1/2-28. I need to get one chopped too, I'm leaning towards 18" at the moment and planned on 1/2-28 but will use a 5/8 adapter on it as needed so I don't run into issues later if I want to use a 556 can that is 1/2-28.

Anything over 6mm I'd just have setup for 5/8-24. $0.02

 

[Joshuajosh]

You can get it threaded with a shoulder added to it can be 5/8-24 but for a 223 I wouldn't since most 223 cans are 1/2-28. I need to get one chopped too, I'm leaning towards 18" at the moment and planned on 1/2-28 but will use a 5/8 adapter on it as needed so I don't run into issues later if I want to use a 556 can that is 1/2-28.

Anything over 6mm I'd just have setup for 5/8-24. $0.02

18 is what I am thinking as well currently

 

[rabbithuntr]

Mine is 16” and I have no regrets but I have not tried 18”

 

[ElPollo]

I cut 223 to 18” and am getting 2750 fps with black hills 77gr TMKs.

 

[wind gypsy]

Mine is 18 and I like it there. Good balance of length and velocity for suppressed use for me.

Lots of good general hunting use 30 cal cans out there what would play double duty well on a 223 and 300 wsm. Sico Scythe, Dead Air nomad Ti XC, OCL hydrogen S ti, LPM Mach-S ti, TBAC ultra 7 all seem to be good options. My 223 wears an ultra7. Since you're wanting a can that works with 30 cals, id just do 5/8 threads (with shoulder) and not worry about adapters.

The CAT JL is a bigger can that intrigues me for max suppression.

 

[mtnbound]

I went with a 18” barrel and run an over the barrel suppressor to which keeps the overall length manageable.

 

[mxgsfmdpx]

If my current 20” 1:8 .223 barrel wasn’t one of the most accurate barrels I’ve ever owned, I’d go with 16-18” and suppress.

I’m not chopping and threading this one, but I do have a stainless threaded 18” barrel to twist on when this one dies. It will be suppressed then.

 

[finner]

17". 2730 with BH 77tmk. Stupid portable and fun with a AB Raptor 6 can with the 3" reflex

 

[StupidLightweight]

I couldn’t decide between 16 or 18, so I went 17”. 2,788 with BH 77s and Banish 223 suppressor. I’d be fine with any of the lengths.