Shell/topper leak question (try to make it waterproof vs bedroll)

[DIYeverything]

Hey yall,

First time posting and first time owning a shell (leer 100xr)-bought used. I get a bit of leaking nothing too crazy but enough to facilitate the need for a cot when sleeping in it. The leaking is just from the rails especially near the cab as seems usual for a lot of shells. for My question to all of you people who sleep in their truck shells is, is it worth me taking the shell off and spending a bunch of time trying to totally seal everything up or just get/make a waxed canvas bed roll and use that on a raised platform?

 

[fngTony]

Not sure I understand where it’s leaking but sealing it will increase condensation unless you have windows to vent?

 

[DIYeverything]

Not sure I understand where it’s leaking but sealing it will increase condensation unless you have windows to vent?

I do have windows to vent. The actual shell it’s self is watertight but the connection where the shell is placed on the bed itself especially near the cab is the area that leaks the most

 

[willtim]

Foam tape.

 

[huntsman22]

silicone caulk.......

 

[Weldor]

Bulb seal, self adhesive. Comes in various sizes and width's.

 

[stank.243]

Seal it. If you're sleeping in dust and your bed is always dusty I'd be willing to bet eventually you'll get sick of it and want it sealed up.

 

[cnelk]

You don’t have to take the topper off.

Get a roll of weatherstripping adhesive tape, undo clamps on one side, gently lift the topper up and prop up with a 2x4 or something.
Install weatherstripping tape and let topper down.
Repeat on other side.

 

[*zap*]

take the top off and put some sill seal on the bed rails..

 

[cnelk]

They actually make a truck topper seal kit

 

[Jason Snyder]

I’ve found it’s exceedingly difficult to get a good seal all the way around. I use the self adhesive bulb seal.

 

[V2Pnutrition]

I get a little leaking at the corners, too. I’ve found two options after chasing my tail to “get it water tight.”

1. 3/8-1/2”Foam pads (the workout type from Costco) to go the length of the bed. The width is fine as is. This raises my paid far enough above the bed liner seams that I’m not in the water.

2. I built a small wooden platform that I keep in there all season. It’s been really nice to provide a platform to sit on and eat, etc. when spending a lot of time in there this time of year with sun set/rise times between hunts.

I’ll typically treat this as a “base camp” if I drive in late and plan to pack in the next day/change spots, etc. It’s nice to come back to and nice to not have to pack/repack all of the gear if changing spots.

I’ve sealed the rails and chased every drip and drop. I finally realized it wasn’t hurting anything and still did what I needed it to, so found a couple of work around to be sure I wasn’t sleeping in the minimal water that was getting in.

 

[Amos Keeto]

Sealing the shell itself to the bed is no biggie! Butyl caulk tape works very well and is easily removed when you pull the shell.
Sealing the tailgate is a whole new ballgame!
....but if you're going to sleep in it, you DO NOT want it "air tight"! You need air exchange.

 

[DIYeverything]

Okay so sounds like its best to just pull it off now and get it as good as I can!