Setting up a Blitzenburger jig and right helical clamp with short vanes

[ontarget7]

Vertically

Cam synch is probably off

 

[rhendrix]

I'll check it tomorrow. Thanks for the input buddy!

 

[ontarget7]

I'll check it tomorrow. Thanks for the input buddy!

No problem
Those bows don't tune best hitting at the same time either. Top cam advanced a little 1/16-1/8 is a good starting point

 

[SDHNTR]

The AZ EZ Fletch doesn't allow you to move your vanes further down the shaft. I run my vane 1" from the nock bushing so I don't have any face contact. I think you have to put the vane in the AZ against the back end or they won't stay in place. I do know the put on the most helical though.

You can get around that easily by jamming tooth pics in the base of the vane slots and breaking them off flush. I don't need to do that as I have no face contact, but know some guys who do.

 

[IrishnId]

You can also use duct tape to space your fletching farther forward. When the clamp on the ez Fletcher is open there's two troughs on the sides of where the fletching sits into, you can run a small strip across it for your one inch forward setting.