Scope Zero Check Thread

[HuntHarder]

5 shot zero check on my Tikka 6CM after ~5 days backpack hunting. 100yds, 1" dot.

View attachment 842537

Stopped after the first 4, dialed down 0.1 and right 0.1, then fired to check. Followed up with another 5 shot group to confirm new zero but didn't grab a pic of that. My best guess on the shift is I had removed and reinstalled my suppressor a few times over the course of the season.

9.75lb Tikka stainless in factory varmint stock, Bartlein #3 6CM 18", Scythe can, Trij Tenmile 3-18x44 mil, UM Tikka Rings/level, all assembled per proper Form method. Shooting ADG brass, Berger 108EH, CCI200 over 40.0gr of H4350 going 2740fps.

What leads you to believe it was your suppressor? Reason I ask is, I constantly unscrew and switch mine amongst other guns and it returns back to zero. Direct thread on mine.

 

[solarshooter]

What leads you to believe it was your suppressor? Reason I ask is, I constantly unscrew and switch mine amongst other guns and it returns back to zero. Direct thread on mine.

Fair question, I honestly don't know what else it could've been, gun wasn't touched otherwise, load hasn't changed, etc etc. I have noticed slightly inconsistent bare muzzle zero's when I shoot without the can, so I kind of figured it was the same effect going the other way. Then again maybe smaller group sizes are the culprit, though the initial zero group was 10rds. So it's possible this group would have filled in and been on zero had I shot more. Within 0.1 is still close so I haven't worried too much.