New Gen 2 SWFA 3-15x42 & 10x Review

[pods8 (Rugged Stitching)]

Ok, Dumb question. Can't someone use a 3-d printer to make a shorter windage cap?

As short as the internals allow (unless you cut those down). But does it gain much over the slim knob?

 

[BBob]

As short as the internals allow (unless you cut those down). But does it gain much over the slim knob?

The gain is it’s capped and one less thing you have to look at to verify it hasn’t moved and it’s a bit smaller. Not a big gain but still a gain.

 

[pods8 (Rugged Stitching)]

The gain is it’s capped and one less thing you have to look at to verify it hasn’t moved. Not a big gain but still a gain.

I’d rather just electrical tape the more robust metal slim turret in place.

 

[sndmn11]

Hey good start

 

[ElPollo]

Hey good start
View attachment 803308
View attachment 803307

Man, you need to go buy a lottery ticket and see if that luck holds.

 

[sndmn11]

 

[HighUintas]

View attachment 803535

It's a bit hard to tell in the photo. Is your zero about 1/2" below the bull? Any changes between top bull and bottom (to right of tracking targets)

 

[sndmn11]

It's a bit hard to tell in the photo. Is your zero about 1/2" below the bull? Any changes between top bull and bottom (to right of tracking targets)

 

[sndmn11]

 

[Ajsomp]

the 10x is one of the Swfa that I haven’t had yet, I feel like I should just to see. Though I think the 3-15 would be a great option even if only used from 3-12

 

[jjohnsonElknewbie]

the 10x is one of the Swfa that I haven’t had yet, I feel like I should just to see. Though I think the 3-15 would be a great option even if only used from 3-12

There is a gen 2 10x on sale in the classifieds for $300.
cc: @Ferrulewax