I recently put new abb strings ont my v3x 33 and I cannot get it to tune. Seems no matter how much I move my rest up I’m getting a nock high tear. After strings were installed I set ata and brace height to spec. Synchronized the cams so the stops are hitting the cables at tge same time. Set my nocking point mid way of ata which puts it right through Berger hole when leveled. I’m shooting 250 black eagle renegades with 175 up front. Ran out of room to adjust my rest. I’m hesitant to lower my nocking point as it would put me about a 1/2 in nock low which just doesn’t seem correct. Using a Hamskea epsilon rest tied to cable yoke. Don’t believe I’m hitting the rest. Does anyone have any ideas on how to get this thing to shoot?