one in every crowd lol. Once I measured it, it’s not bad. This rifle hasn’t shot the best but it’s fineYou’re low.![]()
For 31 shots, I’ll take 1.3”. When I first got it I struggled getting under 1.5”. 1.2-1.3 is about as good as it’ll do. My 25cm is consistently under an inch with 10 shots. Usually in the .8-.9” range.Your definition of “not bad” and mine are different.![]()
Just for clarification I’m saying that’s an amazing group. Not knocking it.For 31 shots, I’ll take 1.3”. When I first got it I struggled getting under 1.5”. 1.2-1.3 is about as good as it’ll do. My 25cm is consistently under an inch with 10 shots. Usually in the .8-.9” range.
I understood it that way. No worriesJust for clarification I’m saying that’s an amazing group. Not knocking it.
We talked a bit about your issue the other day. Got any pictures of the mag fitment with the bolt open. Might help with a resolutionSo I ended up ordering two Ascension mags. Production was a bit slow for Adam, so he sent me a third for free.
Unfortunately, using a KRG Echo, they do not work. I had a positive and lengthy discussion with Adam. Adam is considering purchasing an Echo for his own use and mag development in future. Adam did offer me a full refund since these didn’t work out for me. I’m contemplating if I want to take him up on that offer. Needless to say, fantastic customer service.
The problem the mags have in the chassis is they don’t fully seat on the connection at the rear of the magazine and the mag well. This causes the mag to shift down on the rear of the mag leaving the case too low to be picked up by the bolt. The mag just doesn’t fit as snug as the factory mag, which has zero issues with the Echo.
Here is the mag fully inserted.
View attachment 851108
Here is the mag after you cycle the bolt with a round fed into the chamber.
View attachment 851109
Here is a factory mag for reference.
View attachment 851110
Here is a temporary fix that does work to utilize the magazine. Not ideal, but I can do load development and utilize this mag until I find an extended COAL option that does work with the stock, or Adam gets one and makes an Echo version.
View attachment 851111
I could take my barreled action out of the chassis and go back to the Tikka stock, but that feels like a step backward to me and where I want to go with the rifle.
I emailed ND Shooting supplies, and they claim their 10 round mag will work with the Echo chassis. This will probably be my next try at the Waters mags are crazy expensive (not worth it IMO).
Ok, hopefully I captured helpful pics.We talked a bit about your issue the other day. Got any pictures of the mag fitment with the bolt open. Might help with a resolution
Do you have your magazine spring in place between the trigger screw?Ok, hopefully I captured helpful pics.
Aftermarket mag pushed all the way up. Plenty of grab onto the case.
View attachment 851224
Aftermarket mag in the downward position. Misses the head of the case completely.
View attachment 851223
Factory mag, bolt out.
View attachment 851222
After market mag downward position, bolt out.
View attachment 851221
Aftermarket mag, pushed upward, no bolt.
View attachment 851220
Best I can tell there may be differences in the mag dimensions that may be affecting fit as well as the differences in the heal of the mag.
View attachment 851225