Howa Mini Rifles, Builds, and Upgrades

[KY_coop]

She stumbled about 25 yds in a circle after shot. 103eldx looked like a bomb went off inside.

 

[BBob]

have a competent local gunsmith thread and chamber a barrel for you

They're metric so choose someone that knows that and can thread metric. FWIW the Mini's are M22 x 1 Right in between 24 and 26 TPI.

 

[The Guide]

They're metric so choose someone that knows that and can thread metric. FWIW the Mini's are M22 x 1 Right in between 24 and 26 TPI.

I was cutting metric threads in high school machine shop 30+ years ago. Not hard to do if you have a lathe that can do it. Most lathes manufactured in the last 40 years have the ability to cut metric threads. If a gunsmith refuses to work on Howa Actions and a few other that use metric shank threads, usually it is because their equipment doesn't have the capabilities to do so.

Jay

 

[BBob]

Never said cutting metric was hard. It was only a note and a suggestion to ask before you leap. There’s a lot of old but good lathe’s out there in good gunsmiths shops that don’t cut metric or the transposing gears were lost to the wind long ago.

 

[Bratch]

First kill with the 6 Arc mini. It was supposed to be a deer but turned into a coyote. 103 ELDX is not fur friendly under 50 yards.

 

[JCMCUBIC]

Nice... Every deer hunt is a coyote hunt.

 

[BigWoods]

I could use some help picking ring height.

I have a mini barreled action in 223 inbound from Brownells. I already have a set of 1" Talley lows on the way, but I'm considering picking up one of the Vortex Viper in 2.5-10x44. These are 30mm tube so I'll need to swap out for different rings. Does anyone know if the Medium Talley's will clear that? I'd like to keep the scope as low as possible.

Thanks!

 

[General RE LEE]

I could use some help picking ring height.

I have a mini barreled action in 223 inbound from Brownells. I already have a set of 1" Talley lows on the way, but I'm considering picking up one of the Vortex Viper in 2.5-10x44. These are 30mm tube so I'll need to swap out for different rings. Does anyone know if the Medium Talley's will clear that? I'd like to keep the scope as low as possible.

Thanks!

Mediums will work

 

[Te Hopo]

I could use some help picking ring height.

I have a mini barreled action in 223 inbound from Brownells. I already have a set of 1" Talley lows on the way, but I'm considering picking up one of the Vortex Viper in 2.5-10x44. These are 30mm tube so I'll need to swap out for different rings. Does anyone know if the Medium Talley's will clear that? I'd like to keep the scope as low as possible.

Thanks!

From the early days of my Mini, that's a 42mm objective in 30mm Medium rings.
Heaps of clearance