How do you debur and chamfer consistently on a budget?

[WVELK]

Trying to get opinions on whether one can reliably debur and chamfer consistently with hand tools?

 

[wapitibob]

If you're really good you might get 20 pcs within .005. The reality is, without an optical comparator you'll never know. I suspect .010" variance is fine.

 

[BBob]

What tolerance do you consider is "consistently"? How much do you think it matters? De-burr manually and carry on. FWIW I've de-burred manually for decades and it is what it is. If you're a high volume reloader go buy a machine but for the rest, do it manually if that's what you've got because one isn't going to be better than the other accuracy wise.

For outside I use a Forster hand crank spinner thingy with a Wilson (noted below) deburr tool in it and for inside I use a homemade aluminum handle holder thing with a carbide die grinding burr in it that I spin by hand.

 

[Dos XX]

Case Mouth Burring Tool | Precision Deburring | L.E. Wilson

 

[Marbles]

I don't think the difference matters.

Out of the list of things that probably don't matter and get worried about in reloading, this has to be near the most irrelevant. Unless you sell fance tools, then it really, super duper matters bunches.

 

[Dioni A]

I literally attach my de burring to a drill and do everything by hand hundreds of pieces at a time. I only do the inside. Don't over think it.

 

[Koda_]

Trying to get opinions on whether one can reliably debur and chamfer consistently with hand tools?

Yes.
All you need to do is break the edge. To be consistent just give a hand tool 1 or 2 turns and done.

 

[elephantrider]

Case Mouth Burring Tool | Precision Deburring | L.E. Wilson

^This tool

Yes.
All you need to do is break the edge. To be consistent just give a hand tool 1 or 2 turns and done.

^Used like this. Very minimal pressure to just break the sharp edges off.

 

[wyosam]

My multi step process.
1- Chuck chamfer tool in small drill press next to my bench and turn it on.
2-Briefly touch cases to spinning chamfer tool. 3-Repeat as needed.
4-Be glad I only actually do this for the few flat base bullets I load. Boat tails seem to find their way in and shoot just fine.
5-Reminisce about the period of my life where I obsessed over this sort of thing.


Sent from my iPhone using Tapatalk