Carbon Stock Modifications

[TxLite]

What is the best way to open up the ejection port on this stocky vg? Also need to relieve around the bolt release.

Thinking of using a router or routing bit on a dremel. Obviously with proper PPE and respirator.

 

[SamsonMan22]

I roughed mine in with a carbide burr on a dremel and then finished it with a dremel sanding drum.

 

[Shortschaf]

Dremel 1/4" diameter sanding drum. Black sharpie to finish

 

[TxLite]

Thanks guys. Debating on whether I start modifying this one for final use or send it back due to some general QC issues.

I knew modification would be necessary so not worried about that. But the inletting job sucks. Also some general porosity and overall QC I’m not pleased with for not being marked as a blem.

 

[waspocrew]

Thanks guys. Debating on whether I start modifying this one for final use or send it back due to some general QC issues.

I knew modification would be necessary so not worried about that. But the inletting job sucks. Also some general porosity and overall QC I’m not pleased with for not being marked as a blem.

View attachment 806241
View attachment 806260
View attachment 806261

Dang - it doesn't hurt to ask. Worst they can say is "no". If they aren't willing to fix the stock, then go ahead with the mods.