6 UM Reloading Thread

[Clarktar]

Anyone have any input on using n560? No n570 on my shelves.

 

[Yotekiller]

I don’t understand why people think “fire forming” is such a task. Buy 100pcs of headstamped 6UM brass, load bullets, shoot, hunt with them if you want. Then you have a 100pcs of “formed” brass to reload, add a couple grains of powder, done.

I'm planning to fire form with 115's, N570, & CCI 250. Would you suggest 64 grains? I also have H1000. 61 grains?

 

[PathFinder]

Anyone have any input on using n560? No n570 on my shelves.

560 is probably too fast. 565 would be fine, probably in the low 60s for charge weights.

 

[PathFinder]

I'm planning to fire form with 115's, N570, & CCI 250. Would you suggest 64 grains? I also have H1000. 61 grains?

63 or 64 grains would probably be on the warm side but fine. 61 grains of H1000 would probably do well, that's on the low side for formed cases. Start with 60 maybe.

 

[Clarktar]

560 is probably too fast. 565 would be fine, probably in the low 60s for charge weights.

Too fast for a 15" barrel?

 

[PathFinder]

Too fast for a 15" barrel?

I think so. Even H1000 and 565 are on the fast side for it, though perfectly suitable. 560 will hit pressure at very low fill ratios.

 

[Ryan Avery]

Tanya’s 6UM, The H.O.G.
Took a little more effort to get to shoot. It was the first Pacnor barrel I’ve tried.

67g VV 570
115 Dtac NR
2.91 COL, 70 thou jump
Whidden Dies
.273 bushing
3255 FPS 20” barrel

Sent from my iPhone using Tapatalk Pro

 

[Montane]

I'm seeing pressure signs at 65 and 66 grains of VV N570, which I've not seen in the other posts in this thread.

22" Ace barrel chambered by UM. Whidden Dies, .271 bushing
Fireformed with 60 grains of N570 using DTAC 115 Standard NR No TBN

2nd firing after annealing, all 5 shot groups:
115 DTAC TBN Deep Cut NR, 215GM
2.920 COL, 60 thou jump
64 grains = 3191 FPS, no pressure signs
65 grains = 3275 FPS, light ejector marks, slightly heavy bolt lift
66 grain = 3327 FPS, bright ejector marks, moderately heavy bolt lift

First time I've fireformed or necked down brass so very likely I'm doing something wrong.

I'm around 2.025 length with some at 2.028. So maybe too long? I also see Ryan was using a .273 bushing for Tanya's rifle and I have a .271, so neck tension? Just what this particular barrel/chambering does?

Appreciate any ideas!

 

[GoatPackr]

You could have a slower barrel. That's why we always work up.
Also your barrel isn't broken in yet. Expect more fps when it is.

 

[Jlister]

Has anyone tried h50bmg