Please note: I am still no longer sewing at this time, I don't have enough personal time to do so since it is all hands on work.
Inspired by chatter in the optics forum I put together a shim set for the SWFA 3-9x42 MILRAD(the orange shims below).
Per request a set has been put together for the SWFA 6x42 MILRAD (the green shims below). These fit the other Gen 1 fixed power also. They will physically fit and can be used on the 3-15x42 and MOA scopes providing a variety of shim heights for trial and error fitment but the reference height will not be accurate.
These were based off my personal scopes, even if there is some variance they should have you in the right ballpark and the labeled shims should allow a quick fine tuning from there to adjust up/down mils as needed in the shim stack.
$25 for the first set including shipping (in the US vis USPS), additional sets can be added to the same shipment for $15ea.
Please email [email protected] so I can try to keep communication / orders in one location preferably.
First come, first served add on offer (I will delete this portion of the listing once they are all claimed):
I have some superceeded prototypes of 3d printed tikka M+ mag bodies, these are bodies only and use a factory tikka 3 round M+ follower and spring, which can just be moved over and also moved back, if you want to revert to the factory mag body. These ones have a little more friction on the catridge than the current iteration where I made it internally .2mm wider, it was a minor optimization, these otherwise are functional and are the design ongoing in the diy forum. $5, first come first served to add into the shipment, lets limit it to 1 per person so it widens the field testing feedback pool. Post in this thread if you're claiming one (and which) so we know who was first.
Qty 1: bright orange 3rd M+ mag (photo is washed out below). Claimed
Qty 1 left: black flush fit M+ mags that will fit 2rds
Packaging and quick instruction sheet:
Inspired by chatter in the optics forum I put together a shim set for the SWFA 3-9x42 MILRAD(the orange shims below).
Per request a set has been put together for the SWFA 6x42 MILRAD (the green shims below). These fit the other Gen 1 fixed power also. They will physically fit and can be used on the 3-15x42 and MOA scopes providing a variety of shim heights for trial and error fitment but the reference height will not be accurate.
These were based off my personal scopes, even if there is some variance they should have you in the right ballpark and the labeled shims should allow a quick fine tuning from there to adjust up/down mils as needed in the shim stack.
$25 for the first set including shipping (in the US vis USPS), additional sets can be added to the same shipment for $15ea.
Please email [email protected] so I can try to keep communication / orders in one location preferably.
First come, first served add on offer (I will delete this portion of the listing once they are all claimed):
I have some superceeded prototypes of 3d printed tikka M+ mag bodies, these are bodies only and use a factory tikka 3 round M+ follower and spring, which can just be moved over and also moved back, if you want to revert to the factory mag body. These ones have a little more friction on the catridge than the current iteration where I made it internally .2mm wider, it was a minor optimization, these otherwise are functional and are the design ongoing in the diy forum. $5, first come first served to add into the shipment, lets limit it to 1 per person so it widens the field testing feedback pool. Post in this thread if you're claiming one (and which) so we know who was first.
Qty 1 left: black flush fit M+ mags that will fit 2rds
Packaging and quick instruction sheet:
