Which tikka flush mag for 6.5 prc

[Foster_65]

Anyone have a picture of the beretta mag installed?

 

[Foster_65]

As mentioned, I printed off on of the PRC mags to see how it fit in my rifle.
View attachment 877719
The design prints really nicely in the right orientation, no supports needed.


The length is right for the long and heavy bullets.
View attachment 877720
However, when using the factory PRC mag spring the sidewalls bulge out a bit from the extra pressure. This makes the magazine hard to fit into the well and sometimes the rounds will start coming out of the feed lips
View attachment 877721

I think this is due to the longer spring in the 4rd mag. I think the design would work just fine with a 3rd mag spring.View attachment 877722
I only have the one mag for my rifle, but I might pick up an L mag and see how the spring from that works.

I used the factory spring, bent the last coil out to the same length as a 3 rd spring and snipped the remaining off and it works perfectly. Been using it for nearly a year and have enough rounds through it to be confident with it. No issues feeding. Yes it old fits two but I love these flush mags.

Edit to add I’m using the factory follower