What did you do in the reloading room today?

[49ereric]

Pan lubing 358429 Kieth bullets that were gifted me. I will crimp these just above the driving ban.

 

[BWSmith]

Bought these to eventually stamp a few custom barrels. Which I'll get to....

In the meantime, am practicing the craft stamping some specialty dies/swages/powder rotors that I make for cast bullet shenanigans. Previous sharpie marking on these wasn't hitting on much.... I can see why all the advice about practice is warranted. Am getting the hang of it.

 

[streamerfish]

Well, I think I've gotten to a point where I'm pretty happy with my USPSA pistol load in conjunction with my spring setup in my pistol after some final testing yesterday.

Also my Lock-out die arrived. Got it dialed in.

So its just full production mode now. Rattled off 300 earlier. I will probably run another 200-300 this evening.

I still haven't fully committed to what the new hunting rifle is going to be. But its probably going to be a 6.5 Creed. So, I will probably start gathering components next month for that.

 

[Matt5266]

Ended up doing 300 subsonic 9mm loads this weekend. Not a ton but im a single stage guy.... so just chipping away haha

 

[ResearchinStuff]

Less than I was hoping for. 150 6.5 Creed and a handful of 20 gauge.

 

[DB29]

Dropped H335 into some .223 LC brass for the AR. Putting together practice ammo for my 7 and 10 year old girls.

Look at the price my Grandpa paid for this pound…

 

[Matt5266]

Dropped H335 into some .223 LC brass for the AR. Putting together practice ammo for my 7 and 10 year old girls.

Look at the price my Grandpa paid for this pound…View attachment 1026347

H335 is my favorite AR plinking load powder. Dang good price.... the good Ole days