What did you do in the reloading room today?

[49ereric]

Pan lubing 358429 Kieth bullets that were gifted me. I will crimp these just above the driving ban.

 

[BWSmith]

Bought these to eventually stamp a few custom barrels. Which I'll get to....

In the meantime, am practicing the craft stamping some specialty dies/swages/powder rotors that I make for cast bullet shenanigans. Previous sharpie marking on these wasn't hitting on much.... I can see why all the advice about practice is warranted. Am getting the hang of it.

 

[streamerfish]

Well, I think I've gotten to a point where I'm pretty happy with my USPSA pistol load in conjunction with my spring setup in my pistol after some final testing yesterday.

Also my Lock-out die arrived. Got it dialed in.

So its just full production mode now. Rattled off 300 earlier. I will probably run another 200-300 this evening.

I still haven't fully committed to what the new hunting rifle is going to be. But its probably going to be a 6.5 Creed. So, I will probably start gathering components next month for that.

 

[Matt5266]

Ended up doing 300 subsonic 9mm loads this weekend. Not a ton but im a single stage guy.... so just chipping away haha

 

[ResearchinStuff]

Less than I was hoping for. 150 6.5 Creed and a handful of 20 gauge.