Ultralight Ultralight Rifles

JBradley500 said:
Has anyone thought about a folding bolt handle for the Solo 300? I thought there might be something like the Primary Arms folding magnification lever that could be fitted but I'm coming up short after that. I wouldnt hate trying something like that to keep the bolt from rubbing/opening on my gut when walking in the brush.
Click to expand...
Carrying it for the later half of spring bear, I never had an issue. Have you bumped yours out of battery?

I have another idea for a bolt in the works with a gunsmith…
 
I haven't carried it a ton yet. Mainly at the range and no issues at this point but it just feels like knocking the bolt out of battery is possible.

I do a lot of tree stand hunting on private land so it won't be an issue there. But, I do walk through some pretty thick crap on public land, moving the rifle all over so I don't get hung up, and that's what my concern stems from.
 
As far as a bolt getting knocked out of battery, I"m sure it's probably a little different for each of us and even varies on what we're doing at the time.

Overall you'll probably find it to be less of an issue than you think it might be. When I have my rifle slung on my pack and getting through thick, tough terrain it does happen on occasion from bouncing around against my pack frame (right handed carry), but so would some bolt rifles from the brush.

I've gotten into the habit of an occasional tactile bolt check if there's a round chambered. If there's no round chambered the hammer spring tension holds it closed anyway.

It will be interesting to see Taudisio's creation 👍
 
So I am in my final configuration. Not as light as it once was, but more useful.

The previous red dot wasn't super easy for me to use in bright sun and my eyes were really working OT at 100 yards so I decided to go LPVO. A 1.5-4X range with an actual reticle should be perfect for my hunting area.

Also went from a tiny sling to a ms1. The adjustability and comfort were worth the couple oz.
 

Attachments

  • PXL_20240729_174436694~2.jpg
    PXL_20240729_174436694~2.jpg
    551.9 KB · Views: 55
Last edited:
JBradley500 said:
So I am in my final configuration. Not as light as it once was, but more useful.

The previous red dot wasn't super easy for me to use in bright sun and my eyes were really working OT at 100 yards so I decided to go LPVO. A 1.5-4X range with an actual reticle should be perfect for my hunting area.

Also went from a tiny sling to a ms1. The adjustability and comfort were were the couple oz.
Click to expand...
That's probably about where I'm going to end up. As light as possible on everything except I'll probably keep an NX8 1-8 on it.
 
The magnification range matches up with where I hunt (Northeast). I might shoot a deer at 5 yards or maybe 200 yards... Mostly 25-75 yards. My Leupold weighs 9oz. Can't argue with that weight.
 
As far as knocking out of battery, I spent most of the week before last with mine riding in a Kifaru gunbearer (I ditched all my slings a while back) either hiking around the hills, or riding my little TW200. I took several spills off the bike, including jamming the rifle forend into my chest hard enough to crush the carbon tube & have to rip splinters out of my tit. I slipped &slid down a couple of muddy hills & banks & generally treated everything I had on or with me like shit.
Didn't knock it out of battery once.
 
robtattoo said:
As far as knocking out of battery, I spent most of the week before last with mine riding in a Kifaru gunbearer (I ditched all my slings a while back) either hiking around the hills, or riding my little TW200. I took several spills off the bike, including jamming the rifle forend into my chest hard enough to crush the carbon tube & have to rip splinters out of my tit. I slipped &slid down a couple of muddy hills & banks & generally treated everything I had on or with me like shit.
Didn't knock it out of battery once.
Click to expand...
Note to self: Do not fall on a CF forend.

Maybe my PVC forend isn't such a bad idea after all...
 
Thegman said:
Note to self: Do not fall on a CF forend.

Maybe my PVC forend isn't such a bad idea after all...
Click to expand...
Crushed forend... no biggie. $25 to the ChiWanese ebay people, job done.

Pulling long, barbed, razor sharp splinters out of your own tiddy with wet, filthy fingers & Leatherman pliers? Yeah. Literally as much fun as it sounds.

Pigs don't hear screams though. 🤣
 
JBradley500 said:
The magnification range matches up with where I hunt (Northeast). I might shoot a deer at 5 yards or maybe 200 yards... Mostly 25-75 yards. My Leupold weighs 9oz. Can't argue with that weight.
Click to expand...
The leupolds I get as the weights actually low I more mean the typical strike eagles, NX8s etc that all weigh 18-25ozs.
gtriple said:
Same reason as jbradley. I'm going to try out a few different optics on it though. A compact ACOG is another option. If I could find a good fixed 4x, I could try that.
Click to expand...
Do you actually find the 1x etc any more useful than say a low end of 3x etc of most common variables? I ran a 1-8 on my AR and found I could run a 3-9 for absolutely no loss in functional range. No problem shooting in close range on pigs in the bush here in NZ at 30ish yards range. Maybe it's a personal preference thing but I really found the functional gain of a 1x magnification in a scope was minimal especially for the weight it added over the commonly available and cheaper 2.5-8s or 3-9 type optics. Nowadays I'd likely just try pick up a fixed 3x optic for a sub 100 yard rifle.
 
Anyone happen to have the dimensions of these 17.xx oz 16" barrels? I'm out of town and LRI is ready to go after my green mtn blank, but they want dimensions. I was hoping that they'd just use the previous ones that they had shaved down as a guide, but no luck. I have a faxon at home, but not sure if they are as thin of a profile the 17.xx ones? Thanks for any help, really wanting them to get this thing in line.
 
My upper in 300 HAMR is for sale.

WTS - Solo300 Upper - 300 HAMR

Parts list below. The scope is a Burris 3-9 with the ballistic plex reticle. Sighted in with a 36/200 yard zero with the 125 TNT at 2475 FPS. With scope and mount, (assume I'll keep the Picatinny stock adapter and barrel nut from SOLO), $735 delivered. With out scope and mount $600...
rokslide.com rokslide.com
 
Trackselk said:
Anyone happen to have the dimensions of these 17.xx oz 16" barrels? I'm out of town and LRI is ready to go after my green mtn blank, but they want dimensions. I was hoping that they'd just use the previous ones that they had shaved down as a guide, but no luck. I have a faxon at home, but not sure if they are as thin of a profile the 17.xx ones? Thanks for any help, really wanting them to get this thing in line.
Click to expand...
My unported Shaw, 17.8 oz:
Shank ~0.8"
Tapers to 0.6 at about 2.5"
Hits 0.5" at about 7"
0.5" from there

My Wilson, 19 oz (ported)
Shank ~0.9"
Tapers to 0.48" by ~4.5"
0.48" from there.
(Apparently the 0.75" gas block and muzzle add some weight).

I'd guess that the Wilson profile without the gas block and fat muzzle should get you in the 16s. The Shaw gets you in the 17s.

Look forward to seeing this barrel!

(The shank dimensions are its length, not diameter)
 
Last edited:
@Thegman
Thanks! I ended up sending in the faxon dimensions. They had the shoulder for my can, so it made it easy. I guess I could have them match your Wilson before the shoulder. How's it shoot?
 
Trackselk said:
@Thegman
Thanks! I ended up sending in the faxon dimensions. They had the shoulder for my can, so it made it easy. I guess I could have them match your Wilson before the shoulder. How's it shoot?
Click to expand...
The Wilson shoots fine, it's o.d. is only minimally smaller than the Faxon pencil barrel which is right around 0.5".
 
You must log in or register to reply here.

Similar threads

gtriple
Ultralight Custom Break Action Rifle
2
Replies
39
Views
3K
Trackselk
Trackselk
G
Super dirty brass suppressed AR10 platform
Replies
12
Views
469
khuber84
K
Ferrulewax
Howa Mini Rifles, Builds, and Upgrades
3 4 5
Replies
91
Views
3K
turbobrick
turbobrick
hwy1strat
6ARC feeding issues
Replies
7
Views
236
ARK_Ginger
A
W
Kelbly Action Build - Going Lightweight
Replies
3
Views
164
khuber84
K

Latest posts

Featured Video

Stats

Threads
353,262
Messages
3,726,603
Members
80,661
Latest member
joel.groeneweg

Latest Articles

Back
Top