Torque value on action bolts?

[Silver_Mountain_CO]

I recently purchased a Seekins Precision Havak Element rifle chambered in 7PRC. I purchased the Seekins bipod mount which required me to remove the stock from the receiver/action. I am currently re-installing the receiver to the carbon composite stock. What torque value do I need to use for the two bolts?

I'm stoked to finally get this gun and start shooting. I've been waiting for one for quite some time!

Thank you

 

[mxgsfmdpx]

I recently purchased a Seekins Precision Havak Element rifle chambered in 7PRC. I purchased the Seekins bipod mount which required me to remove the stock from the receiver/action. I am currently re-installing the receiver to the carbon composite stock. What torque value do I need to use for the two bolts?

I'm stoked to finally get this gun and start shooting. I've been waiting for one for quite some time!

Thank you

Call seekins.

 

[Silver_Mountain_CO]

I sent an email. I'm sure I will get a reply tomorrow. Was just hoping someone on here had previous experience so I could get it dialed tonight. Thanks

 

[wnelson14]

Could just use your torque wrench to figure it out. Just start light go up in 5lb increments?

 

[XLR]

45 inch lbs for stocks that are pillar bedded and 65 inch lbs for chassis.

 

[wapitibob]

I use 55 with a Defiance and Manners EH1.

 

[Silver_Mountain_CO]

Hey everyone, thank you for your replies. Seekins sent an email back.... 55in/lbs for those who might also want a quick answer for this. Thanks again!