Threading tikka fluted barrel?

[CoMulies]

Awesome, thanks man! I’ll reach out to em. Any pics of the work?

All I have at the moment, could take close ups later if you want. No shoulder added as he said it wasn’t necessary, there was enough meat there after threading.

 

[ActivelyDying]

All I have at the moment, could take close ups later if you want. No shoulder added as he said it wasn’t necessary.

All good, thanks man

 

[TX_Mike D.]

Reached out to Karl but he said he’s too busy to accept new work and doesn’t know when he’ll be able to. Who else do yall recommend to cut into the flutes on a roughtech, thread 5/8x24 and put a shoulder in?

I will be getting mine back from Paul Hampton next week if the shipping info is correct. His company is called Country Custom Metalsmithing out of Fallon, NV. I can shoot you over a picture once it gets back if you’re interested.

 

[ActivelyDying]

I will be getting mine back from Paul Hampton next week if the shipping info is correct. His company is called Country Custom Metalsmithing out of Fallon, NV. I can shoot you over a picture once it gets back if you’re interested.

Would really appreciate that, thank you.

 

[coues32]

I will be getting mine back from Paul Hampton next week if the shipping info is correct. His company is called Country Custom Metalsmithing out of Fallon, NV. I can shoot you over a picture once it gets back if you’re interested.

I would like a Pic also if you don't mind.

 

[Harvey_NW]

Reached out to Karl but he said he’s too busy to accept new work and doesn’t know when he’ll be able to. Who else do yall recommend to cut into the flutes on a roughtech, thread 5/8x24 and put a shoulder in?

Kinport Peak Rifles in Idaho. I have multiple builds from him and is my primary choice, especially after he fixed what Karl couldn't figure out and gave up on. He was doing a Friday threading deal where that's all he did on Friday's and I got my last one back in a week, not sure now.