Threading “Thin Contour” or “Tikka Lite Contour”Barrels 5/8-24. Flutes Are Welcome!

[General RE LEE]

They look stupid, especially when you cut down the barrel and they don’t have the normal barrel at the end.

That’s one reason. Also, I wouldn’t trust cutting away anymore metal on those super thin barrels.

 

[Antares]

They look stupid, especially when you cut down the barrel and they don’t have the normal barrel at the end.

That's your personal aesthetic preference, not an actual problem.

That’s one reason. Also, I wouldn’t trust cutting away anymore metal on those super thin barrels.

That is something you made up in your mind, not an actual problem.

 

[General RE LEE]

That's your personal aesthetic preference, not an actual problem.



That is something you made up in your mind, not an actual problem.

You do you. Again, if I plan on having a smith cut and thread a barrel, I’m not buying a Superlite. The Lite models are just fine.

 

[Antares]

You do you. Again, if I plan on having a smith cut and thread a barrel, I’m not buying a Superlite. The Lite models are just fine.

You are aware that the Lites and Superlites are the same barrel profile, right?

 

[ALF]

I was once concerned about cutting & threading a fluted barrel, but I got over it.

The flutes stop at the can, big deal, doesn't bother me in the least.

The flutes were so deep on this Remington Varmint contour, he went with 1/28 threads.