SWFA 3-9 Low Profile Turret Interest

[Marbles]

For capping the windage on the 3-9, is it possible to modify the factory turret cap to where it doesn’t rotate the turret stem? Asking since I ordered two on their sale, but haven’t had any hands on with the 3-9

You could drill out the splines, but the screw still goes into the brass post.

I may try that with the free BDC turrets.

 

[Schmo]

You could drill out the splines, but the screw still goes into the brass post.

I may try that with the free BDC turrets.

Yeah I was thinking along those lines. Maybe drill out the splines, and then maybe figure out a washer setup under the cap screw where the cap could free spin without rotating the stem. Obviously the electrical tape will work, but trying to figure out another solution that doesn’t require tape to hold.