Show your Tikka ten round groups

[brockel]

 

[mtnwrunner]

Tikka 223 ctr, 77 tmk, trijicon ten mile.
600 yards.

And I have no idea of where the 10th one is.

Randy

 

[Seeknelk]

Tikka factory barrel @ 16.5 inch suppressed with Dominus CB. Norma URP powder showing good velocity and consistency. Need to check temp stability a bit. 100 yards. Did this at 18" also with no muzzle device with same load.

 

[Seeknelk]

It also loves the 136 ScenarL.

 

[Pharmseller]

If you guys would focus on your breathing, those groups would tighten right up.




P

 

[PlumberED]

6.5 cm T3x CTR, SF SOCOM Ti suppressor
10 shots in 5ish minutes
40.5 H4350
140 grain Hornady BTHP
CCI 200
Hornady brass

 

[ManOfSteel]

10rds of CCI SV out of the T1x at 75yds today. Not phenomenal but it’ll work for small game hunting. First one was all me.

 

[Slowshot18]

The T3x lite in 6.5 creed got a makeover. Barrel chopped and threaded to 1/2”, made the stock look kool with some Krylon, put on an ATACR 4-16 in milR, UM rings, and a TBAC 338 ultra can, and it is still hammering with factory ammo. Since I purchased this rifle, I’ve sold off all but one of my custom R700 actions, barrels, stocks etc and purchased a stainless t3x in 223. It’s about to be sent off for threading so it can wear a can.

 

[amassi]

Tikka 223 ctr, 77 tmk, trijicon ten mile.
600 yards.

And I have no idea of where the 10th one is.

RandyView attachment 622415

Sent from my iPhone using Tapatalk

 

[Pickettpuncher]

It’s 8 instead of 10. Tikka t3 30-06.

 

[BAKPAKR]

The T3x lite in 6.5 creed got a makeover. Barrel chopped and threaded to 1/2”, made the stock look kool with some Krylon, put on an ATACR 4-16 in milR, UM rings, and a TBAC 338 ultra can, and it is still hammering with factory ammo. Since I purchased this rifle, I’ve sold off all but one of my custom R700 actions, barrels, stocks etc and purchased a stainless t3x in 223. It’s about to be sent off for threading so it can wear a can.
View attachment 624565
View attachment 624566View attachment 624567

You need a smaller suppressor…

 

[Slowshot18]

You need a smaller suppressor…

The 338 ultra is overkill from my days of needing large magnum cartridges, but man is it quiet. I have a rugged micro30 and it’s nowhere near the sound reduction of the 338.

 

[swavescatter]

Black Hills TMK from Tikka 223 compact. Got a little impatient and pulled shots 9/10.

 

[sveltri]

Not to impressive, but here’s my ladder test from today wind was pretty bad and shooting directly into the sun. I crushed the first charge of the ladder because my die was not setup correctly so only 9 shots. .223 77TMK N540 Velocities:
1 22.8 2623
2 23.1 - not recorderd
3 23.4 2709
4 23.7 2767
5 24.0 2794
6 24.3 2864
7 24.6 2855
8 24.9 2918
9 25.2 2986

 

[pattimusprime22]

Tikka T3X D18 223 with Rugged Radiant, Black Hills Factory 77 TMKs.

First 10 shots after rough boresight



Next 9 shots after turret adjustment:


I'll take it.

 

[Wyo_hntr]

10rds 6 creed factory 108eldm

 

[TX_Diver]

View attachment 624664
Not to impressive, but here’s my ladder test from today wind was pretty bad and shooting directly into the sun. I crushed the first charge of the ladder because my die was not setup correctly so only 9 shots. .223 77TMK N540 Velocities:
1 22.8 2623
2 23.1 - not recorderd
3 23.4 2709
4 23.7 2767
5 24.0 2794
6 24.3 2864
7 24.6 2855
8 24.9 2918
9 25.2 2986

What barrel length? Some of those velocities seem pretty quick!

 

[wind gypsy]

You need a smaller suppressor…

He musta missed the memo. pEnCil bArREls AreNt stIfF EnoUgH FoR sUPreSsorS. Need a stiff carbon barrel if you want to keep it lightweight.

 

[Castle Rock]

Shot my CTR at my local f class match

 

[sveltri]

What barrel length? Some of those velocities seem pretty quick!

24”