Rokstok Lite

[flyfisher117]

I am to mock up and see what lengths feel good for myself now that I determined I want longer. Didn’t know till I had it in hand (I don’t have spacers in my rokstok regular currently). No clue if the outline of mine is standard or not (note the bit of angle on the toe I mentioned above, @flyfisher117 is yours like that?). Haven’t decided if I’ll just figure out a length and reuse the coarse screws or install some rivnuts (I have a kit from a different project).

Is UM not offering spacers for these? I didn’t pay attention since I can make my own personal ones. I assumed they are and if so any reason not to get those?

I will check the bottom angle of mine. I hadn’t noticed anything but I didn’t look that close.

They will be offering spacers eventually. Just don’t have any and no eta when they will get them. I was hoping to tinker with LOP sooner than later.

 

[JDZ]

Just for anyone reading, they send the full LOP kit regardless of size you ask for. So even if you want 13.75”, you’ll get the extra spacers regardless

Then why would @pods8 (Rugged Stitching) need to be working on spacers? I'm confused.

 

[pods8 (Rugged Stitching)]

Then why would @pods8 (Rugged Stitching) need to be working on spacers? I'm confused.

I posted a picture of the stock pad off (for reference for others) and commented that I wanted a longer length of pull, @IrkedCitizen guessed I was likely making something based on the knowledge I 3d print swfa shims and tikka mags. I replied saying I was working on something for myself and pointed out if UM is selling them users should just get them from UM and in that way they'll also get threaded inserts too (I believe).

 

[43.6N]

Has anybody heard back about the thicker recoil pad?

 

[FB Trout]

Has anybody heard back about the thicker recoil pad?

I have, this is the email chain:

Hi,
I ordered a Rokstok Lite last Thursday, 2/12/26,
and was wondering if I could do the 1” grind to fit Pachmayr pads, instead of the 1/2”? Also, I’d like to delete the single rear sling stud, as well, so no sling studs. Thanks much

Response:
Hey there, We should be able to do that, we don't have any of the lites on hand as of right now, So therefor its hard telling. What we can do is put a note in the system and we can keep you updated as time and orders progress.

Logan Ronnenberg - Rokstok Manager
(208) 444-2420

 

[43.6N]

I have, this is the email chain:

Hi,
I ordered a Rokstok Lite last Thursday, 2/12/26,
and was wondering if I could do the 1” grind to fit Pachmayr pads, instead of the 1/2”? Also, I’d like to delete the single rear sling stud, as well, so no sling studs. Thanks much

Response:
Hey there, We should be able to do that, we don't have any of the lites on hand as of right now, So therefor its hard telling. What we can do is put a note in the system and we can keep you updated as time and orders progress.

Logan Ronnenberg - Rokstok Manager
(208) 444-2420

Thanks, I hadn’t heard anything after my initial email. I’ll be sure to follow up on it when I confirm cerakote.

 

[FB Trout]

Thanks, I hadn’t heard anything after my initial email. I’ll be sure to follow up on it when I confirm cerakote.

You bet, hope all goes well!