Prime Bow Tuning Help

[BKhunter]

Hey all,

I’m tuning my prime which was set up my a pro shop. Shooting a bare shaft through paper at about 5-6 ft I’m getting a bad tear which I can’t tell if it is nock high left or nock low right. I believe it is low right. The first three arrows shot are the far right three in the photo the furthest left is with 1 turn let off from the flex is bolt attached to the riser and the second from the left is with two turns off. The bolt was originally all the way cranked down. Not sure what the issue is here as this is my first go at tuning. Can anyone lend some ideas?

Sent from my iPhone using Tapatalk

 

[Ucsdryder]

What prime bow?

Hey all,

I’m tuning my prime which was set up my a pro shop. Shooting a bare shaft through paper at about 5-6 ft I’m getting a bad tear which I can’t tell if it is nock high left or nock low right. I believe it is low right. The first three arrows shot are the far right three in the photo the furthest left is with 1 turn let off from the flex is bolt attached to the riser and the second from the left is with two turns off. The bolt was originally all the way cranked down. Not sure what the issue is here as this is my first go at tuning. Can anyone lend some ideas?

Sent from my iPhone using Tapatalk

 

[BKhunter]

Hello,

I am shooting a Centergy set to 70#

 

[Ucsdryder]

To get rid of a low tear I had to advance the top cam. There are a ton of good videos on tuning the centergy line. Check on YouTube. I had little to no success with the flexis. Once the bow is tuned you can fine tune with the flexis at long range.

 

[BKhunter]

If it's a low tear you are saying I should add a twist or two to the top cam cable? If it is a high tear should I do two to the lower cam? Sorry if this seems basic, this is the first time I am tuning a bow myself. Should I also fully tighten the flexis all the way as it was originally?

 

[Ucsdryder]

Prime Centergy In Depth Tuning video

It's about 20 min long but some good info for the DIY guys. Prime Centergy - YouTube Sent from my iPhone using Tapatalk

www.rokslide.com

Start here. I can’t remember now which way I did it. I put the top cam sync marks ahead of “neutral” if I remember correctly. It was 3 years ago and I forgot! Haha