Polymer / lightweight magazines 300 PRC

[AFmaryland]

I see there are some metal AICS magazines for the 300 PRC but when building a light hunting rifle I’d rather shed some weight if possible.

Any suggestions on a lightweight option for the 300 PRC magazine?

 

[IrkedCitizen]

Unknown Munitions DBM bottom metal and magazine.

 

[AFmaryland]

Unknown Munitions DBM bottom metal and magazine.

Would this work with a chassis though? I didn’t think you could do a bottom metal with a chassis

 

[IrkedCitizen]

Would this work with a chassis though? I didn’t think you could do a bottom metal with a chassis

Correct.

Polymer magazines are thicker to take the abuse. Thicker means less available length. 300prc is 3.7" so that isn't feasible.

Run an MK Machining single shot sled then single feed. That's the lightest option

 

[AFmaryland]

Correct.

Polymer magazines are thicker to take the abuse. Thicker means less available length. 300prc is 3.7" so that isn't feasible.

Run an MK Machining single shot sled then single feed. That's the lightest option

I’ll check it out thank you

 

[LostWapiti]

I just got the newish MDT 3 round polymer magazine meant for 300WM to work for 300 PRC. Out of the box it is barely long enough but I filed the front inside to give it a little more length and then had to file the inside of the mag just a little where the shoulder of the case is so that it slides smoothly while feeding.

 

[ChrisAU]

I just got the newish MDT 3 round polymer magazine meant for 300WM to work for 300 PRC. Out of the box it is barely long enough but I filed the front inside to give it a little more length and then had to file the inside of the mag just a little where the shoulder of the case is so that it slides smoothly while feeding.

Interesting. May have to try this myself.

 

[wind gypsy]

MDT has CIP length 3 rd polymers.