Po"tay"to Po"ta"to ... is 70 70?

[philcox]

Thinking I know the answer, but throwing it out here for some discussion (confirmation?).

I currently shoot a Nexus 2 (32") @ 70lbs, 28.5" DL. The bow has a 6" brace height and a 341 IBO. I was looking at a Lift X 29.5. IBO is 348 brace height is 6". I shoot a 438g 28.25" arrow. The only reason I was looking at the lift was to get more "distance", but the more I thought about it, I kind of figured that the arrow trajectory if both bows are @ 70lbs, is going to be essentially the same, and thus they are likely going to have very similar "distance" limitation (e.g., arrow hit the sight).

Seems to me that essentially any bow with similar IBO, Brace Height, and Riser Length (seems like adv to Nexus on this one, but not sure how much 2.5" matters).

Thoughts?

 

[Marble]

Phil, i would try moving your peep a little bit to give you more distance.

How far can you shoot now and far do you want to shoot?

Sent from my SM-S918U using Tapatalk

 

[philcox]

Phil, i would try moving your peep a little bit to give you more distance.

How far can you shoot now and far do you want to shoot?

Sent from my SM-S918U using Tapatalk

About 85. For 3D is like 110. I’ll give the peep a try.

 

[PathFinder]

Peeps are best off staying where they belong for a proper anchor. Moving them up does help a lot to get more adjustment though.
The 7 fps might get you 5 or 10 more yards. Not much.
Going to a smaller housing or additional pin nearer the bottom of the housing is the other way to do it.

Sent from my Pixel 6 using Tapatalk

 

[Marble]

About 85. For 3D is like 110. I’ll give the peep a try.

Just put a permanent marker mark on your string for reference or measure it.

How much you can move it kind of depends on how you set it up to begin with. If you set it up using a 20-yard target, then you'll have a lot of room. If you started with a target in your mid range, then you'll have less wiggle room.

I forget which sight you have, but if it extends in or out, having it closer to the bow will help also.

I struggled with this one for the wife. A combination of extra draw weight, pulling the sight in and a peep movement got her to over 100 yards. Just don't let her out shoot you in June...

Sent from my SM-S918U using Tapatalk

 

[tkhuntsman]

Best option is to get a good 5 pin sight with dual indicators (black gold, spot hog, axcel they all have the option) set it up so your 40 yard pin is close to centered ( 3rd pin). Use your housing adjustments to do this. Then do your 30 and 20 yard pins (second and first). Adjust pins only. Then do a 50 yard pin under the 40 adjust the pin only. Set your first indicator and star your tape at 50 with the dial all the way at the top position. Take your last pin (5th one down) set it 1/8 inch above your level at the bottom of your sight. It's probably going to be close to 75 or 80 yards you will have to do some shooting to figure this out. Set your second indicator to whatever that pin ends up being sighted for. Dial your sight down with an arrow knocked until it's 1.75" above your arrow to the bottom of your housing. Draw a red line on your tape next to whatever distance your 50 yard indicator stops at and a green line at whatever distance your bottom indicator stops at. Now you know both max yardages and it's probably going to be farther than anybody should reasonably shoot a bow. Some sights out there will have a dial stop that you can set at your bottom position so that you can't go past it just have to do a little research to figure out which ones.