Pics of fluted barrels that have been threaded?

[thinhorn_AK]

I’ve seen it discussed that you can get threaded barrels cut/threaded, maybe even collared for 5/8x24 but I guess I’ve missed the pictures of it.

Can you post up pics if you have done it? I have a tikka with a fluted barrel I’d like to get shortened up.

 

[JollyRoger]

Here’s a few. Top rifle is threaded but with a blended cap.
Bottom rifle is a factory Tikka Veil barrel

 

[Cameron.25]

Tikka i had rechambered, fluted, chopped with 5/8x24 adapter by kampfield

 

[JollyRoger]

I just realized what you are actually asking…. Shortening an existing fluted barrel to have threaded. My bad

 

[Cameron.25]

I just realized what you are actually asking…. Shortening an existing fluted barrel to have threaded. My bad

Same haha

Edit to add: i think form has posted a pic of one

 

[hereinaz]

I was about to post a pic too, but I think I realized he is wanting pics where the barrel is shortened into the fluting and then threaded?

 

[KHNC]

I had to a pay a bit more for my T3X in blued non-fluted because my GS said he couldnt thread into the fluted section. I have since found a GS that actually knows what he is doing an can do it. Already had bought the non-fluted barrel tho.

 

[thinhorn_AK]

I just realized what you are actually asking…. Shortening an existing fluted barrel to have threaded. My bad

My bad, yes. It's early and The coffee hasn't quite kicked in.

Looking for pics of barrels that have been cut off in the fluted area. I have a t3x that has a 24.3" barrel, I'd like it to be 18" which is a few inches into the fluting.

 

[thinhorn_AK]

I was about to post a pic too, but I think I realized he is wanting pics where the barrel is shortened into the fluting and then threaded?

yeah sorry, looking at my OP I could have been more clear.

 

[TX_Diver]

6.5cm superlite at 19" ish... Think it had to go 1/2x28 but don't remember 100%.

 

[atmat]

@Formidilosus has posted some before.

 

[silasbowhunter]

I’ll post pics tomorrow evening of my buddies 22-250 superlite that he had shortened into the flutes and threaded. It is 1/2x28 tho


Sent from my iPhone using Tapatalk

 

[Jimbee]

It looks exactly the same as a non fluted barrel, but with flutes.

 

[ndhuntermanND]

I’m thinking hard about doing this to a seekins ph2.

Figure there’s enough barrel ‘meat’ in the flute valley to run 9/16-24..

 

[Mmomn]

 

[Jimbee]

Threaded 1/2x28 with some cheap 5/8 adapters.

 

[Lonewolf72]

6.5cm superlite at 19" ish... Think it had to go 1/2x28 but don't remember 100%.

Is that an Area 419 adapter?

 

[TX_Diver]

Is that an Area 419 adapter?

Yes.

 

[Tom-D]

Has anyone had it cut down and had an end cap or muzzle break machined to look like the end of the flute again? If you get what im saying