Painless load development (mine)

[Castle Rock]

At the risk of being branded a "painful" reloader, are you guys getting 4-5 firings of 223 without annealing? (I'm assuming @Formidilosus's is "I never anneal")

I get over 15 on Lapua before trimming and annealing

 

[Hardly_Hangin]

Someone asked earlier in this thread about # of firings they get from 223 or 6 arc brass and IIRC they are shooting wiht an AR. I've not put a ton of firings on brass used in AR before but it's sure harder on brass than a bolt gun is so I wouldn't expect as good of results in that regard. Also, i'd bump shoulders more on brass intended for an AR so you're working the brass more.

Thatd be me!

i wasnt sure if id get more or less loadings. Gas gun pressures in theory would be less than bolt gun pressures (extending brass life?) and my gun is a stright pull repeater not semi-auto (extending brass life?)

My OCD tries to get the best of me a lot at the bench, and I do my best to force it back down. LOL!

Same here - the painless method is like a sigh of releif that i dont have to be so OCD about it, cause it just works

 

[wind gypsy]

Thatd be me!

i wasnt sure if id get more or less loadings. Gas gun pressures in theory would be less than bolt gun pressures (extending brass life?) and my gun is a stright pull repeater not semi-auto (extending brass life?)


Same here - the painless method is like a sigh of releif that i dont have to be so OCD about it, cause it just works

Yeah, i'd think a straight pull would be closer to a bolt gun in that regard and easier on brass. Probably doesnt get it all filthy like a gas gun does either.

 

[Hardly_Hangin]

Yeah, i'd think a straight pull would be closer to a bolt gun in that regard and easier on brass. Probably doesnt get it all filthy like a gas gun does either.

Definitely cleaner, especially shooting suppressed

 

[wind gypsy]

I get over 15 on Lapua before trimming and annealing

Yes but you're a neck sizing weirdo that doesn't mind resistance on bolt close.

 

[Castle Rock]