As we have talked about earlier in this thread, it can take 3+ years to cycle through our 60+ offerings. Due to supply and demand, more popular casings have a more frequent run cycle. I can assure you we are at full tilt with 24/7 production in our 3 cells!
This is great! Thank you, very much. I'm annealing after each firing and bumping headspace about 0.001"-0.002", so I'm less worried about neck splits. However, I'm still relatively new to reloading and haven't had to worry about case head separation, yet. I'm not loading hot, either, so hopefully that will really help extend my brass life, too.
Should add some 25-06 in there too
If y’all made 25-06 brass I’d build another one. Could be a popular come back with the new high BC bullets coming out. Same for 257bob. Brass options is the main reason not to have one.
So if I understand the articles correctly. Now that @Peterson Cartridge Co makes the 300 and 270wsm then only logical next cartridge would be the 6.8western?
Nice read, makes a lot of sense on what you need on your end to bring products to the market.
That is correct! They share the same family so development of the 6.8 Western should be streamlined should we decide to make it. This is absolutely an open avenue after the WSM's are completed, but that doesn't necessarily mean we are going that direction. Certainly possible though!
How many you gonna buy if they do?
I'd be trying to pick up 500 pieces
A couple hundred to start.
With this in mind do you have a ROUGH timeline when 6.5-284 is cycling back through again?
Same here for 6.8 Western
It is TENTATIVELY anticipated to run Q3 2025. That is a very rough estimate as our schedule is only set firmly 3 months in advance.
Understood, thanks.
