MDT Hnt26 diy buttpad above centerline mod

[Choot]

. I haven’t tried to get them super tight, just snugged them down good and mine haven’t given me any issues. If you used the epoxy to just glue the nut down instead of filling the surrounding void I can see how that could break free. The instamoph fills in the surrounding void and locks it in so it can’t spin. Jb weld would probably work good to. Once my instamorph set up I did tack it in there with a dab of superglue just so it wouldn’t fall out.

 

[snowypit]

I'm about to do this. To confirm, you're using 4 screws now? Two screws that came with the stock to attach the spacer that's aligned at the original height and the two new screws to attach the offset/raised spacer where the buttpad goes?

 

[Choot]

I'm about to do this. To confirm, you're using 4 screws now? Two screws that came with the stock to attach the spacer that's aligned at the original height and the two new screws to attach the offset/raised spacer where the buttpad goes?

Correct