JGRaider
WKR
That would actually be 16-1700fps for partition/accubond.
I thought that figure was for the Accubond long Range and the standard Accubond was roughly 400 FPS different?That would actually be 16-1700fps for partition/accubond.
Fudlore.........some the old logic is retarded. A 140 6.5 has way better sectional density and far superior BC than any 140 7mm. Past 300y the 65 is gonna over take it in all performance aspects. I've always felt the 7mm is a lil lost, too much of a tweener. 65s shoot much softer and have similar ballistics when comparing high bc options, and big 30 cal mags just push so much more weight down range. If 1 tool had to be chosen to hunt all N American game with, I'd probably go with a 7saum tho. It's kinda that goldilocks IF you could only have one.My 6.5 PRC shoots the new Federal Fusion Tipped 140 grainers at 3035 FPS (20 shot average) chronoed with my Garmin.
7RM's shoot 140's arond 3100-3150. Are you honestly going to think that an elk won't die with 75-100 fps less in the same bullet weight?
This conversation in lunacy.
The bright side of reading this for me is that your 500 dollar Tikka worked perfectly. I have piles of custom rifles too. It's funny though, my first Tikka in 30-06 shoots as good for a hunting rifle as any of them. I always tell my friends getting into hunting to grab a Tikka. Not sexy with custom paint jobs and carbon fiber, but they work. I do get it though, I prefer to take my "nicer" rifles as well. Guides see a lot of bad shots and bad ammo choices. So they figure a 30-06 is a safe bet for them not to have to guess. Those guys sometimes aren't super fancy, they just hunt and shoot stuff they can grab at Walmart. Forgot my ammo on a hunt and a guide dug a 30-06 out of his glove box that another hunter left behind. Put it in my my Tikka and limited my range to 150 and it workedI recently shot my first Elk. The guide insisted I use a .30 cal instead of my 6.5 PRC. I obliged with my 30-06 Tikka. The big bull went 3 steps. Great day.
It started me thinking about cartridges. My 6.5 PRC is a Proof Elevation MTR 24" bbl. For me, It is the most accurate rifle I own. It loves the Berger 156 gr EOL that I purchased from Choice and achieves 3010 fps. It shoots UM loaded 147 ELD-m at 2975 fps. My Carbon Six 24" barreled 30-06 Tikka groups 165 gr Accubonds very well at 2940 fps and shoots Barnes 168 gr TTSX even faster at 3025 fps. My friend has a Tikka 24" 7mm Rem Mag that shoots factory 162 gr ELD-x at 2925 fps.
I realize I am comparing different bullets and factory ammo to semi-custom ammo but these are the cartridges I personally saw chronographed. After entering the info in a ballistics calculator, the 6.5 PRC, at 300 yards, has considerably more velocity then any of the others. It has more energy, less drop and less drift plus a higher sectional density. Because of the higher BC bullets the 6.5 PRC has an even bigger advantage at 400 and 500 yards.
Is the 6.5 PRC really the marginal cartridge for Elk simply because it is 6 gr less weight and .020 less diameter? Is the issue that most feel the 180 gr bullet in the 06 or the 7mm is a much better choice for bigger game?
I might buy those numbers for the partition, but not for the accubond. A buddy of mine uses them. They don’t open up nearly as well at low velocities as the old partition. Barnes used to say the TTSX had a minimum expansion velocity of 1600. But that meant the tip of the bullet would barely start to open. It is still an FMJ at that point. I doubt the accubond is much better at that speed.That would actually be 16-1700fps for partition/accubond.
7mm's are inadequate commie euro trash. Adding a belt and calling it a magnum doesn't change that. There is a reason we wone WWII, and thats .30 bore diameters.The 7 mag will continue to be one of the most popular western cartridges because it works reliably. Other smaller cartridges may work reliably with the correct bullet, but none of the 7 mag shooters I know have ever felt the need to dissect and photograph bullet performance to prove it works. It just works.
I almost bought into the 6.5 PRC as a replacement for my 7 mag, but with the bullets and range I like to hunt at, the PRC is very very close to the 270 - both shoot a 140 gr bullet at about the same velocity. I upgraded from the 270 back in the 1980’s because my mentor’s 7 mag spanked the 270 when shot side by side, taking animals side by side. In that respect, I don’t see the similar PRC as a bad cartridge, it’s just not a great one, like a 160gr in the 7 mag.
A lot of guys will want to say, “Yeah, but. . . ,” and try to make excuses for, or justify the 6.5 - nobody feels they have to do that with the 7 mag.
Even older than the 7 mag is the 264 win mag, and shot side by side, seeing the performance on game side by side, most guys like the extra bullet weight of the 7 mag and the 264 never gained a lot of fanfare.
well, it's really simple.
girls in grade school like boys thin and lightweight
girls in high school like guys with some size and weight
girls in college like guys with some size, weight, and athletics
girls post-college like guys with size, weight, athletics and power
there you have it...like I said, simple. now can we move on from the .223 BS?
I feel like this sums it up. 6.5 prc > 7rm. So no you do not need a 7mm.My brother’s 6.5 PRC shoots the 156 EOL into little bitty groups at 2934 fps MV.
Doing the ballistics voodoo it’s superior to our 162 ELDX load from our 7mm Rem Mags.
That’s plenty.
P
I feel like this sums it up. 6.5 prc > 7rm. So no you do not need a 7mm.
I am starting to slowly migrate towards that myself. I think im done reloading my 300 win. Just 6.5 creed and 300 wsm now. Maybe ill just sell everything a buy a 6.5 prc lol.Lots of overlap with the Mighty -08 and the 7mm Rem Mag. I tease him that I’m not gonna load for the other two rifles for him anymore now that he has the 6.5 PRC.
P
I am starting to slowly migrate towards that myself. I think im done reloading my 300 win. Just 6.5 creed and 300 wsm now. Maybe ill just sell everything a buy a 6.5 prc lol.