Hornady full length re-sizing die assembly question

Joined
Feb 12, 2014
Messages
377
Location
Oklahoma
New set of dies and I disassembled to clean. Screwing it back together and it started to bind. Is this o ring installed correctly? It seems not. Can someone show me a pic of their die ready for assembly and all of the parts please? The decapper assy. wont screw in completely due to this o ring it seems.
146407816_420161152740728_7005973828294636957_n.jpg
 
I just checked mine. It is just like the pic. It has resistance while screwing in and out but goes no problem.

I can take a pic if you need.
 
Thank you. I have another question. 146684162_459489405404578_908566053780226310_n.jpgIn the seating die there are two small parts listed as 15 and 19 I (seating stem) n the instructions. I think one is for the ELDX bullet? I can see a visible difference in them bow do I know which one is which? They aren't marked.
 
I just use which ever one fits the bullet I am seating the best, Just make sure it does not push on bullet tip.

I believe the standard stem comes installed new,

However, I am very new to reloading myself. Might want to wait for an answer from someone else.

Thank you for your service.
 
Last edited:
Thank you for your support! Thanks for the help too. I disassembled the die to clean it so I'm not sure which one is in there now.
 
Back
Top