Favorite .270 Bullets?

[Deere_Man]

150gr Winchester Power Point

 

[83cj-7]

140 grain Accubonds with RL26 @ 3100 fps from a 22” barrel.

I used to run the 140 Accubond out of a 270 at 2870 and the damage it did to deer was unreal. I can’t even imagine what it does at 3100!

 

[KU_Geo]

130s or 140s?

130 and 140 accubonds, 140 tipped game kings, 150 partitions. For those not too worried about BC, the 150 partition is a killin’ sonabitch from 0-550yds.

 

[Anschutz]

If I was shooting longer distances or going out west I’d use ELD x. No experience with it that ammo in this cartridge. But I would trust it based on its popularity with so many shooters across lots of other calibers.

Hornady Precision Hunter 270 Winchester Ammo 145 Grain Hornady ELD-X

Accuracy and terminal performance are the cornerstones of Hornady Precision Hunter factory loaded ammunition. Great care has been given by...

www.midwayusa.com

It's good stuff. I got consistent hits on an 8" plate from field positions (mostly sitting with a sling or off my pack) out to 500 yards. Then turned around and shot caribou at 125ish and 30ish offhand.

Terminal Performance was acceptable. Both dropped in their tracks. The further shot was broadside and went through both shoulders and made a lump under the offside hide. The core and jacket were together but separated during skinning.

The closer one was frontal. I only found a sliver of jacket but the lungs were damaged. I didn't look too hard for more.

 

[HunterMc24]

130 and 140 accubonds, 140 tipped game kings, 150 partitions. For those not too worried about BC, the 150 partition is a killin’ sonabitch from 0-550yds.

The odds of me shooting past 550 are slim in the area I’m in. May give those 150s a run and see how they shoot in it.

 

[nm.otter]

If I was shooting longer distances or going out west I’d use ELD x. No experience with it that ammo in this cartridge. But I would trust it based on its popularity with so many shooters across lots of other calibers.

No shortage of specific reports on 145gr ELD-X performance -- almost all coming from legacy twist-rate barrels.

 

[roadrunner]

130 or 140 gr AB's

 

[HunterMc24]

130 or 140 gr AB's

Definitely gonna give those a try and see how they shoot

 

[HunterMc24]

It's good stuff. I got consistent hits on an 8" plate from field positions (mostly sitting with a sling or off my pack) out to 500 yards. Then turned around and shot caribou at 125ish and 30ish offhand.

Terminal Performance was acceptable. Both dropped in their tracks. The further shot was broadside and went through both shoulders and made a lump under the offside hide. The core and jacket were together but separated during skinning.

The closer one was frontal. I only found a sliver of jacket but the lungs were damaged. I didn't look too hard for more.

Have personally always been a fan of Hornady. Shot the ELD-X in some other calibers and had good results.

 

[roadrunner]

Definitely gonna give those a try and see how they shoot

They shoot well. I'm not for one who cares for "big" wound channels. Anything you hit with these in organs that are vital (yes, including liver/spleen/paunch) either die quickly or lay down quickly for a follow-up.

 

[Taprack9]

I’ve had great luck with 130 monos. Barnes TTSX and Federal Premium Copper. (Nosler Etips)

All of my shots have been fairly close so I’ve had a lot of speed and haven’t had any issues with performance. Out of the last 8 deer furthest one went 20 yards.

 

[Speaks]

Used federal fusions for years. They were fine and did what I expected of them.

 

[6mm Remington]

130 gr. Nosler Accubonds or Partitions are never a mistake. As is the 130 gr. Nosler E-tip.
H4831SC seems to be a good classic powder (So says Jack O'Connor) as is H4350 or IMR4350.
With H4831SC load I worked up for a friend I used Federal 215 Magnum primers when doing so. It worked very well. With H4350 or IMR4350 I would just use Federal 210's.