BARTLEIN BARRELS CUSTOMER SERVICE EXPERIENCE

[Wrench]

Curious tangent here - if slugging a bore, borescope inspection, and measured run-out dont indicate any manufacturing issues, what do you think is a reasonable expectation from a barrel manufacturer?

I would have to think you've touched on everything. It looks good as far as surface finish and the chambering went well....it just shoots like garbage.

I didn't slug it because they wanted it back dirty, but hearing these stories I just elected to take a $425 loss vs that plus shipping to hear a story. I lost a lot of faith with the "10 twist isn't enough".

 

[TxLite]

I would have to think you've touched on everything. It looks good as far as surface finish and the chambering went well....it just shoots like garbage.

I didn't slug it because they wanted it back dirty, but hearing these stories I just elected to take a $425 loss vs that plus shipping to hear a story. I lost a lot of faith with the "10 twist isn't enough".

Did you try shooting anything lighter to confirm that the barrel is the issue?

10 twist should absolutely be enough but it would be an easy way to squash that argument with them and get your money back.

 

[Wrench]

Did you try shooting anything lighter to confirm that the barrel is the issue?

10 twist should absolutely be enough but it would be an easy way to squash that argument with them and get your money back.

I shot berger 215s and 200.20x neither was better than 3moa consistently. The new tube is a hammer with those as well.

 

[ihookem]

Well, after all these posts, I got to wondering. I have no interest in a Magnum blaster that runs 100 gr. of powder . That being said, I live 20 miles from Bartlein Barrels and would likely go with them if I want a custom barrel.. Some questions are, just for target shooting, what would be the most practical cartridge? I have 223 Rem. Seems like it would be real easy on the barrel. A 6.5 Creedmore? A .308 Win. is much more than I need for 200 yd. paper. I have met some of the guys from Bartlein Barrels at my gun club. They sure like their guns. The ones I saw were at least 1.25" barrels and very expensive scopes . They all out shot me . However, I still could run well under an inch with my Savage 12 bull barrel in .223Rem. They were all right around .5" and some even less. That said , I think wonder what Frank would say about a 200 Yd. target gun. He has not been on here in a long time.

 

[khuber84]

One really bad experience with a Bartlein carbon. I documented 250 rounds. Sent in photos, targets, load data. The barrel would walk right approx 1.5 MOA for the first 6-8 rounds, and then stack small groups till the barrel was too hot to touch. It did this repetitively with multiple loads. They inspected the barrel, told me it was dirty, and basically told me to pound sand. Bottom line, F Bartlein, I'll never shoot one their barrels again unless it was a life or death situation.