6.5 RPM experience?

83cj-7

WKR
Joined
Dec 26, 2020
Messages
1,170
Location
West Virginia
Does anyone have any real world experience with this cartridge? Accuracy with factory ammo and or hand loads? Speeds with various powders and bullets?

I have read about everything I can find online, just looking for experiences from anyone on RS.
 

WormSportsman

Lil-Rokslider
Joined
Mar 20, 2017
Messages
214
Location
Montana
I have been shooting the Weathermark LT in 6.5 WBY RPM this past year. The only factory ammo I could find last year when purchasing the gun was the 140gr accubond and it shoots it sub moa and chronographed avg of 3066 last time at the range. I have recently purchased a bunch of accubond long range in 142gr and 150gr bullets that I am hoping to reload the next few months with IMR 4350 and H-1000 to see what I can get out of them. Shot an antelope at 380 yards and a mule deer at 420 yards this season and they went a combined total of 5 steps. Love my RPM so far!
 

amassi

WKR
Joined
May 26, 2018
Messages
3,882
Backcountry shoots 143 eldx and 140 sierra tgk sub moa over a case full of retumbo. 127 lrx shoots great too for work here in CA. The factory 140ab and 127 lrx shot great too.

Sent from my SM-G991U using Tapatalk
 

Murtfree

Lil-Rokslider
Joined
Aug 23, 2019
Messages
178
I just picked up a Backcountry in 6.5RPM yesterday. I am planning on starting out with the 140gr Accubond over N570, and if that doesn’t work RE33 or Retumbo. I will hopefully know more in a few weeks
 

Sykes

WKR
Joined
May 13, 2018
Messages
572
I had a Weathermark LT. It shot the factory 127 lrx load the best at around 1/2 moa. The 140 accubonds were a solid 3/4 moa. My wife killed a nice mulie with the 127 lrx at around 200 yards. 1 shot. I killed a 5x5 bull elk with the 140 accubonds at 80 yards. Hit him twice but only needed the first shot, it did him in pretty good. Both bullets exited.
I worked up a load with a 124 hammer hunter and RL25 that shot pretty good, 1/2-3/4. It was fast, around 3250, out ran my 6.5 prc by 100 fps if I remember right, may have been faster. Pretty sure I just tossed all my targets and notes from that rifle last week. Really it is a pretty great round for fast and flat shooting.
 

amassi

WKR
Joined
May 26, 2018
Messages
3,882
I just picked up a Backcountry in 6.5RPM yesterday. I am planning on starting out with the 140gr Accubond over N570, and if that doesn’t work RE33 or Retumbo. I will hopefully know more in a few weeks
Retumbo, 8133 have shone the brightest with the 140s.
H1k, 7977 and N565 with the 124-130gr
N570 was a dud in my rifles, thankfully as it's tough to find and spendy.
Also I'm using fed 215m fwiw

Sent from my SM-G991U using Tapatalk
 

mainbeam pursuit2

Lil-Rokslider
Joined
Mar 6, 2016
Messages
167
Location
Parker, Co.
When i was at Weatherby last spring I spent quite a bit of time discussing loads with their ballistician. He suggested retumbo for accuracy and 869 for higher velocity. The retumbo with a 215 primer works well in my RPM. I tried 869 but with a 210 primer, that was a no go. I'm going to try 869 again with a 215 primer. He also claimed they were seeing good results from magpro in some of their testing.
 

amassi

WKR
Joined
May 26, 2018
Messages
3,882
When i was at Weatherby last spring I spent quite a bit of time discussing loads with their ballistician. He suggested retumbo for accuracy and 869 for higher velocity. The retumbo with a 215 primer works well in my RPM. I tried 869 but with a 210 primer, that was a no go. I'm going to try 869 again with a 215 primer. He also claimed they were seeing good results from magpro in some of their testing.
The factory ammo I pulled all had ball powder like us869. I'll take the stability of retumbo over the moderate velocity bump of 869

Sent from my SM-G991U using Tapatalk
 
Joined
Mar 30, 2021
Messages
77
Bought a Weathermark LT last summer and love how it shoots on paper with the 127 lrx factory. Haven’t had an opportunity on game yet with it but that’s more user error than the gun. Only shot a whitetail last fall and I didn’t want that to be my first kill with it. It’s been a joy packing around the mountains though, 7.5lbs fully setup with a sling. I have no question it’ll perform when I need it to
 

amassi

WKR
Joined
May 26, 2018
Messages
3,882
I think they were using 869, i agree with amassi about the retumbo.
75.7 gr of this with the factory 140AB
cc7fefa8b63ff551e80c50bd1971cc57.jpg


Sent from my SM-G991U using Tapatalk
 

Murtfree

Lil-Rokslider
Joined
Aug 23, 2019
Messages
178
Amassi and Mainbeam may have a point with Retumbo. N570 was clearly the best powder I tried in the 6.5-300 for accuracy and speed; 1/2 to 3/4 inch groups at 3490 with the 140AB. RE33 was one ragged hole in the 257 Bee with a 110 Accubond. Retumbo didn’t fair to well in either but just may be the ticket with case volume to bore diameter for the RPM with the shorter barrel. I haven’t found anything that liked 869 or LRT in the accuracy department but were good for velocity.
 
OP
83cj-7

83cj-7

WKR
Joined
Dec 26, 2020
Messages
1,170
Location
West Virginia
Is RL26 considered “too fast” I wonder? I would think it would do good for the lighter bullets.
 

amassi

WKR
Joined
May 26, 2018
Messages
3,882
Is RL26 considered “too fast” I wonder? I would think it would do good for the lighter bullets.
Might net you some meager extra velocity but is too sensitive to temp changes for me. The burn rate is right though, I suspect h4831, imr4955 would work well with 120-130gr bullets

Sent from my SM-G991U using Tapatalk
 

WormSportsman

Lil-Rokslider
Joined
Mar 20, 2017
Messages
214
Location
Montana
Worked up some starting loads for the Accubond LR 150gr bullets this morning for the RPM. Worked up from 57.5 grains and ended at 60.5 gr of H-1000 at 2837 no pressure signs. Ended there as that was all I had time to shoot and reload this morning. Will continue to load up from there but pretty pleased with my first pass with the 150’s so far. Can’t wait to see what it can do in the weeks to come.
 

mainbeam pursuit2

Lil-Rokslider
Joined
Mar 6, 2016
Messages
167
Location
Parker, Co.
I'll be interested to see where you end up with 150 ABLRs, I have some that I've been wanting to load up. I'm sure I'll get a little different result with the 24" barrel on my backcountry.
 

BjornF16

WKR
Joined
Dec 12, 2019
Messages
2,611
Location
Texas
I have a Backcountry in 6.5 RPM.

Factory 127 LRX shoots well. Factory 140 Interlock doesn’t do well in my rifle.

I’ve been looking for Factory 140 Accubond to try but haven’t found any.

I’ve hand loaded 124 Hammer Hunters with excellent accuracy. I have some 143 ELDX and 147 ELDM to try.
 

amassi

WKR
Joined
May 26, 2018
Messages
3,882
Worked up some starting loads for the Accubond LR 150gr bullets this morning for the RPM. Worked up from 57.5 grains and ended at 60.5 gr of H-1000 at 2837 no pressure signs. Ended there as that was all I had time to shoot and reload this morning. Will continue to load up from there but pretty pleased with my first pass with the 150’s so far. Can’t wait to see what it can do in the weeks to come.
Keep goin
Hodgdon went up to 63.0 with a 150 sierra hpbt for 3030fps.
Retumbo in my rifle got the 150 to 3100fps with no pressure.
Also the data on the hodgdon reloading data center is quite mild.

Sent from my SM-G991U using Tapatalk
 

amassi

WKR
Joined
May 26, 2018
Messages
3,882
I'll be interested to see where you end up with 150 ABLRs, I have some that I've been wanting to load up. I'm sure I'll get a little different result with the 24" barrel on my backcountry.
65.0 gr retumbo 150ablr got me 3100 with my backcountry at 3.340coal
Fwiw- these are way off the lands but shot really good.

Sent from my SM-G991U using Tapatalk
 
Top