Not sure what that goes for down south these days but that jug would cost me around 600$ Canadian before tax right now. Wild times we live in.Cracked open a new 8lber. Sad I paid this just 3 years ago and through I was over paying.
View attachment 769248
Looks like you hit him with a blender!View attachment 769424Antelope, 2500ish fps impact vel, 77 TMK
Idaho goat?View attachment 769424Antelope, 2500ish fps impact vel, 77 TMK
WyoIdaho goat?
I was wondering what Mag you are running. I have the same rifle and it shoots the 73’s great but it is a lot easier to find the 75’s around here but from what I have read the 75’s don’t seem to work at factory tikka mag length75 Eldm advice in a 1-8” Tikka
Looking for recipes for my Superlite .223. I have Varget, H4895, Benchmark, and TAC. I use CCI 400 primers. I call load long, into the lands if need be. Thanks, Pwww.24hourcampfire.com
2934, 24” Tikka Varmint.
P
Did you have to change anything else with your rifle. I was doing some reading on some 3d printed mags and some people are saying you might have to change the bolt stopI have some of those Australian mags but now I’m using the 3-D printed mags. Cheaper and lighter.
I can load into the lands if I want.
P
no change with the waters rifleman mags, id be surprised if the new 3d printed ones needed a bolt stop modification too.Did you have to change anything else with your rifle. I was doing some reading on some 3d printed mags and some people are saying you might have to change the bolt stop
Not an expert, but probably from a 3D printer.Where do you get the 3d printed mags?