- Thread Starter
- #41
HellsCanyon
WKR
Come on mike you have to finish up my rifle! I can’t wait to see it!
All in good time bud!
Mike
Come on mike you have to finish up my rifle! I can’t wait to see it!
Can you post a picture of how the shoulder will look on a tikka action?
Sent from my iPhone using Tapatalk
I’ll see if I can’t find a picture. If required I can run a 1.200” tennon OD but have to know from the start so I can turn the tennon down before wrapping.
Also, I get a LOT of questions regarding threading the muzzle of my barrels. There is at minimum .635” OD of steel underneath (.700” for 338 cal). You can machine the carbon with HSS or Carbide tooling just like you do stainless and cut whatever threads needed. Because of my fiber orientation you can time a break on it. It’s very stable and machines great.
For those of you using suppressors, I’m having a run gunsmith thread adapters made, they’re 1/2:32 ID thread and 5/8:24 OD thread with enough Steel shoulder OD to be blended to whatever length and OD your barrel finishes at. The 32TPI has a much higher holding capacity so a small drop of loktight and it’ll stay secure when tightening/loosening a 5/8:24 pitch brake!
I’ll be adding these to the website next week and will offer them as an installed option as well as raw part for your smith to install.
I just touched down at SHOT show so I’m out of the shop this week!
Mike
Sent from my iPhone using Tapatalk
aint nothing like waiting on your NEW rifle to be finished.
With quality factory and blueprinted/trued Rem SA what accuracy can one expect from your barrels with a high BC round like 6.5CM or 300 PRC?
Any plans for another group buy?
Sent from my iPhone using Tapatalk